x86/gart: Disable GART explicitly before initialization

If we boot into a crash-kernel the gart might still be
enabled and its caches might be dirty. This can result in
undefined behavior later. Fix it by explicitly disabling the
gart hardware before initialization and flushing the caches
after enablement.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>

arch/x86/kernel/aperture_64.c

@@ -393,6 +393,7 @@ void __init gart_iommu_hole_init(void)
 	for (i = 0; i < ARRAY_SIZE(bus_dev_ranges); i++) {
 		int bus;
 		int dev_base, dev_limit;
+		u32 ctl;
 
 		bus = bus_dev_ranges[i].bus;
 		dev_base = bus_dev_ranges[i].dev_base;
@@ -406,7 +407,19 @@ void __init gart_iommu_hole_init(void)
 			gart_iommu_aperture = 1;
 			x86_init.iommu.iommu_init = gart_iommu_init;
 
-			aper_order = (read_pci_config(bus, slot, 3, AMD64_GARTAPERTURECTL) >> 1) & 7;
+			ctl = read_pci_config(bus, slot, 3,
+					      AMD64_GARTAPERTURECTL);
+
+			/*
+			 * Before we do anything else disable the GART. It may
+			 * still be enabled if we boot into a crash-kernel here.
+			 * Reconfiguring the GART while it is enabled could have
+			 * unknown side-effects.
+			 */
+			ctl &= ~GARTEN;
+			write_pci_config(bus, slot, 3, AMD64_GARTAPERTURECTL, ctl);
+
+			aper_order = (ctl >> 1) & 7;
 			aper_size = (32 * 1024 * 1024) << aper_order;
 			aper_base = read_pci_config(bus, slot, 3, AMD64_GARTAPERTUREBASE) & 0x7fff;
 			aper_base <<= 25;

arch/x86/kernel/pci-gart_64.c

@@ -564,6 +564,9 @@ static void enable_gart_translations(void)
 
 		enable_gart_translation(dev, __pa(agp_gatt_table));
 	}
+
+	/* Flush the GART-TLB to remove stale entries */
+	k8_flush_garts();
 }
 
 /*