mmc: usdhi6rol0: Inform the mmc core about the maximum busy timeout

Some commands uses R1B responses, which means the card may assert the DAT0
line to signal busy for a period of time, after it has received the
command. The mmc core normally specifies the busy period for the command in
the cmd->busy_timeout. Ideally the driver should respect it, but that
requires quite some update of the code, so let's defer that to someone with
the HW at hand.

Instead, let's inform the mmc core about the maximum supported busy timeout
in ->max_busy_timeout during ->probe(). This value corresponds to the fixed
4s timeout used by usdhi6rol0. In this way, we let the mmc core validate
the needed timeout, which may lead to that it converts from a R1B into a R1
response and then use CMD13 to poll for busy completion.

In other words, this change enables support for commands with longer busy
periods than 4s, like erase (CMD38) for example.

Cc: Jesper Nilsson <jesper.nilsson@axis.com>
Cc: Lars Persson <lars.persson@axis.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
Acked-by: Jesper Nilsson <jesper.nilsson@axis.com>
Link: https://lore.kernel.org/r/20200414161413.3036-6-ulf.hansson@linaro.orgSigned-off-by: Ulf Hansson <ulf.hansson@linaro.org>

drivers/mmc/host/usdhi6rol0.c

@@ -136,6 +136,8 @@
 
 #define USDHI6_MIN_DMA 64
 
+#define USDHI6_REQ_TIMEOUT_MS 4000
+
 enum usdhi6_wait_for {
 	USDHI6_WAIT_FOR_REQUEST,
 	USDHI6_WAIT_FOR_CMD,
@@ -1763,7 +1765,12 @@ static int usdhi6_probe(struct platform_device *pdev)
 	host		= mmc_priv(mmc);
 	host->mmc	= mmc;
 	host->wait	= USDHI6_WAIT_FOR_REQUEST;
-	host->timeout	= msecs_to_jiffies(4000);
+	host->timeout	= msecs_to_jiffies(USDHI6_REQ_TIMEOUT_MS);
+	/*
+	 * We use a fixed timeout of 4s, hence inform the core about it. A
+	 * future improvement should instead respect the cmd->busy_timeout.
+	 */
+	mmc->max_busy_timeout = USDHI6_REQ_TIMEOUT_MS;
 
 	host->pinctrl = devm_pinctrl_get(&pdev->dev);
 	if (IS_ERR(host->pinctrl)) {