net/mlx4_en: Remove unnecessary warn print in reset config

In mlx4_en_reset_config, there was a redundant warn print that was left
from previous versions of this function. No warn is needed anymore.

This warn can be confusing when RX-FCS is changed:
Turn OFF RX-FCS:
  mlx4_en: eth1: Changing device configuration rx filter(0) rx vlan(1)
Turn ON RX-FCS:
  mlx4_en: eth1: Changing device configuration rx filter(0) rx vlan(1)
Signed-off-by: Eran Ben Elisha <eranbe@mellanox.com>
Signed-off-by: Tariq Toukan <tariqt@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/mellanox/mlx4/en_netdev.c

@@ -3634,10 +3634,6 @@ int mlx4_en_reset_config(struct net_device *dev,
 		mlx4_en_stop_port(dev, 1);
 	}
 
-	en_warn(priv, "Changing device configuration rx filter(%x) rx vlan(%x)\n",
-		ts_config.rx_filter,
-		!!(features & NETIF_F_HW_VLAN_CTAG_RX));
-
 	mlx4_en_safe_replace_resources(priv, tmp);
 
 	if (DEV_FEATURE_CHANGED(dev, features, NETIF_F_HW_VLAN_CTAG_RX)) {