Merge branch 'ethtool-reset-AP'

Scott Branden says:

====================
net: ethtool: add support for ETH_RESET_AP

Add support to reset appplication processors inside SmartNICs by
defining new ETH_RESET_AP bit.

And use new ETH_RESET_AP bit in bnxt ethernet driver.
====================
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/broadcom/bnxt/bnxt_ethtool.c

@@ -1376,6 +1376,9 @@ static int bnxt_firmware_reset(struct net_device *dev,
 		req.embedded_proc_type = FW_RESET_REQ_EMBEDDED_PROC_TYPE_CHIP;
 		req.selfrst_status = FW_RESET_REQ_SELFRST_STATUS_SELFRSTASAP;
 		break;
+	case BNXT_FW_RESET_AP:
+		req.embedded_proc_type = FW_RESET_REQ_EMBEDDED_PROC_TYPE_AP;
+		break;
 	default:
 		return -EINVAL;
 	}
@@ -2522,6 +2525,14 @@ static int bnxt_reset(struct net_device *dev, u32 *flags)
 		rc = bnxt_firmware_reset(dev, BNXT_FW_RESET_CHIP);
 		if (!rc)
 			netdev_info(dev, "Reset request successful. Reload driver to complete reset\n");
+	} else if (*flags == ETH_RESET_AP) {
+		/* This feature is not supported in older firmware versions */
+		if (bp->hwrm_spec_code < 0x10803)
+			return -EOPNOTSUPP;
+
+		rc = bnxt_firmware_reset(dev, BNXT_FW_RESET_AP);
+		if (!rc)
+			netdev_info(dev, "Reset Application Processor request successful.\n");
 	} else {
 		rc = -EINVAL;
 	}

drivers/net/ethernet/broadcom/bnxt/bnxt_ethtool.h

@@ -34,6 +34,7 @@ struct bnxt_led_cfg {
 #define BNXT_LED_DFLT_ENABLES(x)			\
 	cpu_to_le32(BNXT_LED_DFLT_ENA << (BNXT_LED_DFLT_ENA_SHIFT * (x)))
 
+#define BNXT_FW_RESET_AP	0xfffe
 #define BNXT_FW_RESET_CHIP	0xffff
 
 extern const struct ethtool_ops bnxt_ethtool_ops;

include/uapi/linux/ethtool.h

@@ -1686,6 +1686,7 @@ enum ethtool_reset_flags {
 	ETH_RESET_PHY		= 1 << 6,	/* Transceiver/PHY */
 	ETH_RESET_RAM		= 1 << 7,	/* RAM shared between
 						 * multiple components */
+	ETH_RESET_AP		= 1 << 8,	/* Application processor */
 
 	ETH_RESET_DEDICATED	= 0x0000ffff,	/* All components dedicated to
 						 * this interface */