Merge remote-tracking branches 'spi/fix/atmel', 'spi/fix/bcm2835',...

Merge remote-tracking branches 'spi/fix/atmel', 'spi/fix/bcm2835', 'spi/fix/doc', 'spi/fix/mediatek', 'spi/fix/meson', 'spi/fix/mtk' and 'spi/fix/pxa2xx' into spi-linus

Documentation/devicetree/bindings/spi/spi-mt65xx.txt

@@ -15,17 +15,18 @@ Required properties:
 - interrupts: Should contain spi interrupt
 
 - clocks: phandles to input clocks.
-  The first should be <&topckgen CLK_TOP_SPI_SEL>.
-  The second should be one of the following.
+  The first should be one of the following. It's PLL.
    -  <&clk26m>: specify parent clock 26MHZ.
    -  <&topckgen CLK_TOP_SYSPLL3_D2>: specify parent clock 109MHZ.
 				      It's the default one.
    -  <&topckgen CLK_TOP_SYSPLL4_D2>: specify parent clock 78MHZ.
    -  <&topckgen CLK_TOP_UNIVPLL2_D4>: specify parent clock 104MHZ.
    -  <&topckgen CLK_TOP_UNIVPLL1_D8>: specify parent clock 78MHZ.
+  The second should be <&topckgen CLK_TOP_SPI_SEL>. It's clock mux.
+  The third is <&pericfg CLK_PERI_SPI0>. It's clock gate.
 
-- clock-names: shall be "spi-clk" for the controller clock, and
-  "parent-clk" for the parent clock.
+- clock-names: shall be "parent-clk" for the parent clock, "sel-clk" for the
+  muxes clock, and "spi-clk" for the clock gate.
 
 Optional properties:
 - mediatek,pad-select: specify which pins group(ck/mi/mo/cs) spi
@@ -44,8 +45,11 @@ spi: spi@1100a000 {
 	#size-cells = <0>;
 	reg = <0 0x1100a000 0 0x1000>;
 	interrupts = <GIC_SPI 110 IRQ_TYPE_LEVEL_LOW>;
-	clocks = <&topckgen CLK_TOP_SPI_SEL>, <&topckgen CLK_TOP_SYSPLL3_D2>;
-	clock-names = "spi-clk", "parent-clk";
+	clocks = <&topckgen CLK_TOP_SYSPLL3_D2>,
+		 <&topckgen CLK_TOP_SPI_SEL>,
+		 <&pericfg CLK_PERI_SPI0>;
+	clock-names = "parent-clk", "sel-clk", "spi-clk";
+
 	mediatek,pad-select = <0>;
 	status = "disabled";
 };

drivers/spi/spi-atmel.c

@@ -1720,6 +1720,7 @@ static int atmel_spi_runtime_resume(struct device *dev)
 	return clk_prepare_enable(as->clk);
 }
 
+#ifdef CONFIG_PM_SLEEP
 static int atmel_spi_suspend(struct device *dev)
 {
 	struct spi_master *master = dev_get_drvdata(dev);
@@ -1756,6 +1757,7 @@ static int atmel_spi_resume(struct device *dev)
 
 	return ret;
 }
+#endif
 
 static const struct dev_pm_ops atmel_spi_pm_ops = {
 	SET_SYSTEM_SLEEP_PM_OPS(atmel_spi_suspend, atmel_spi_resume)

drivers/spi/spi-bcm2835.c

@@ -386,14 +386,14 @@ static bool bcm2835_spi_can_dma(struct spi_master *master,
 	/* otherwise we only allow transfers within the same page
 	 * to avoid wasting time on dma_mapping when it is not practical
 	 */
-	if (((size_t)tfr->tx_buf & PAGE_MASK) + tfr->len > PAGE_SIZE) {
+	if (((size_t)tfr->tx_buf & (PAGE_SIZE - 1)) + tfr->len > PAGE_SIZE) {
 		dev_warn_once(&spi->dev,
 			      "Unaligned spi tx-transfer bridging page\n");
 		return false;
 	}
-	if (((size_t)tfr->rx_buf & PAGE_MASK) + tfr->len > PAGE_SIZE) {
+	if (((size_t)tfr->rx_buf & (PAGE_SIZE - 1)) + tfr->len > PAGE_SIZE) {
 		dev_warn_once(&spi->dev,
-			      "Unaligned spi tx-transfer bridging page\n");
+			      "Unaligned spi rx-transfer bridging page\n");
 		return false;
 	}
 

drivers/spi/spi-meson-spifc.c

@@ -444,6 +444,7 @@ static const struct of_device_id meson_spifc_dt_match[] = {
 	{ .compatible = "amlogic,meson6-spifc", },
 	{ },
 };
+MODULE_DEVICE_TABLE(of, meson_spifc_dt_match);
 
 static struct platform_driver meson_spifc_driver = {
 	.probe	= meson_spifc_probe,

drivers/spi/spi-mt65xx.c

@@ -85,7 +85,7 @@ struct mtk_spi {
 	void __iomem *base;
 	u32 state;
 	u32 pad_sel;
-	struct clk *spi_clk, *parent_clk;
+	struct clk *parent_clk, *sel_clk, *spi_clk;
 	struct spi_transfer *cur_transfer;
 	u32 xfer_len;
 	struct scatterlist *tx_sgl, *rx_sgl;
@@ -173,22 +173,6 @@ static void mtk_spi_config(struct mtk_spi *mdata,
 		writel(mdata->pad_sel, mdata->base + SPI_PAD_SEL_REG);
 }
 
-static int mtk_spi_prepare_hardware(struct spi_master *master)
-{
-	struct spi_transfer *trans;
-	struct mtk_spi *mdata = spi_master_get_devdata(master);
-	struct spi_message *msg = master->cur_msg;
-
-	trans = list_first_entry(&msg->transfers, struct spi_transfer,
-				 transfer_list);
-	if (!trans->cs_change) {
-		mdata->state = MTK_SPI_IDLE;
-		mtk_spi_reset(mdata);
-	}
-
-	return 0;
-}
-
 static int mtk_spi_prepare_message(struct spi_master *master,
 				   struct spi_message *msg)
 {
@@ -228,11 +212,15 @@ static void mtk_spi_set_cs(struct spi_device *spi, bool enable)
 	struct mtk_spi *mdata = spi_master_get_devdata(spi->master);
 
 	reg_val = readl(mdata->base + SPI_CMD_REG);
-	if (!enable)
+	if (!enable) {
 		reg_val |= SPI_CMD_PAUSE_EN;
-	else
+		writel(reg_val, mdata->base + SPI_CMD_REG);
+	} else {
 		reg_val &= ~SPI_CMD_PAUSE_EN;
-	writel(reg_val, mdata->base + SPI_CMD_REG);
+		writel(reg_val, mdata->base + SPI_CMD_REG);
+		mdata->state = MTK_SPI_IDLE;
+		mtk_spi_reset(mdata);
+	}
 }
 
 static void mtk_spi_prepare_transfer(struct spi_master *master,
@@ -509,7 +497,6 @@ static int mtk_spi_probe(struct platform_device *pdev)
 	master->mode_bits = SPI_CPOL | SPI_CPHA;
 
 	master->set_cs = mtk_spi_set_cs;
-	master->prepare_transfer_hardware = mtk_spi_prepare_hardware;
 	master->prepare_message = mtk_spi_prepare_message;
 	master->transfer_one = mtk_spi_transfer_one;
 	master->can_dma = mtk_spi_can_dma;
@@ -576,13 +563,6 @@ static int mtk_spi_probe(struct platform_device *pdev)
 		goto err_put_master;
 	}
 
-	mdata->spi_clk = devm_clk_get(&pdev->dev, "spi-clk");
-	if (IS_ERR(mdata->spi_clk)) {
-		ret = PTR_ERR(mdata->spi_clk);
-		dev_err(&pdev->dev, "failed to get spi-clk: %d\n", ret);
-		goto err_put_master;
-	}
-
 	mdata->parent_clk = devm_clk_get(&pdev->dev, "parent-clk");
 	if (IS_ERR(mdata->parent_clk)) {
 		ret = PTR_ERR(mdata->parent_clk);
@@ -590,13 +570,27 @@ static int mtk_spi_probe(struct platform_device *pdev)
 		goto err_put_master;
 	}
 
+	mdata->sel_clk = devm_clk_get(&pdev->dev, "sel-clk");
+	if (IS_ERR(mdata->sel_clk)) {
+		ret = PTR_ERR(mdata->sel_clk);
+		dev_err(&pdev->dev, "failed to get sel-clk: %d\n", ret);
+		goto err_put_master;
+	}
+
+	mdata->spi_clk = devm_clk_get(&pdev->dev, "spi-clk");
+	if (IS_ERR(mdata->spi_clk)) {
+		ret = PTR_ERR(mdata->spi_clk);
+		dev_err(&pdev->dev, "failed to get spi-clk: %d\n", ret);
+		goto err_put_master;
+	}
+
 	ret = clk_prepare_enable(mdata->spi_clk);
 	if (ret < 0) {
 		dev_err(&pdev->dev, "failed to enable spi_clk (%d)\n", ret);
 		goto err_put_master;
 	}
 
-	ret = clk_set_parent(mdata->spi_clk, mdata->parent_clk);
+	ret = clk_set_parent(mdata->sel_clk, mdata->parent_clk);
 	if (ret < 0) {
 		dev_err(&pdev->dev, "failed to clk_set_parent (%d)\n", ret);
 		goto err_disable_clk;
@@ -630,7 +624,6 @@ static int mtk_spi_remove(struct platform_device *pdev)
 	pm_runtime_disable(&pdev->dev);
 
 	mtk_spi_reset(mdata);
-	clk_disable_unprepare(mdata->spi_clk);
 	spi_master_put(master);
 
 	return 0;

drivers/spi/spi-pxa2xx.c

@@ -654,6 +654,10 @@ static irqreturn_t ssp_int(int irq, void *dev_id)
 	if (!(sccr1_reg & SSCR1_TIE))
 		mask &= ~SSSR_TFS;
 
+	/* Ignore RX timeout interrupt if it is disabled */
+	if (!(sccr1_reg & SSCR1_TINTE))
+		mask &= ~SSSR_TINT;
+
 	if (!(status & mask))
 		return IRQ_NONE;
 

drivers/spi/spi.c

@@ -1610,8 +1610,7 @@ static struct class spi_master_class = {
  *
  * The caller is responsible for assigning the bus number and initializing
  * the master's methods before calling spi_register_master(); and (after errors
- * adding the device) calling spi_master_put() and kfree() to prevent a memory
- * leak.
+ * adding the device) calling spi_master_put() to prevent a memory leak.
  */
 struct spi_master *spi_alloc_master(struct device *dev, unsigned size)
 {

include/linux/spi/spi.h

@@ -34,7 +34,7 @@ extern struct bus_type spi_bus_type;
 
 /**
  * struct spi_statistics - statistics for spi transfers
- * @clock:         lock protecting this structure
+ * @lock:          lock protecting this structure
  *
  * @messages:      number of spi-messages handled
  * @transfers:     number of spi_transfers handled