Commit 5b39de91 authored by Matt Carlson's avatar Matt Carlson Committed by David S. Miller

tg3: Add ability to turn off 1shot MSI

In older devices, 1-shot MSI mode had to be enabled by the code.  In
newer devices however, 1-shot MSI mode is enabled by default; code would
be needed to disable it.

Disabling 1-shot MSI mode is useful when debugging.  This patch changes
the code so that the TG3_FLAG_1SHOT_MSI accurately reflects (and
controls) the state of 1-shot MSI mode.
Signed-off-by: default avatarMatt Carlson <mcarlson@broadcom.com>
Reviewed-by: default avatarBenjamin Li <benli@broadcom.com>
Reviewed-by: default avatarMichael Chan <mchan@broadcom.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 81389f57
......@@ -5712,7 +5712,7 @@ static irqreturn_t tg3_msi(int irq, void *dev_id)
* NIC to stop sending us irqs, engaging "in-intr-handler"
* event coalescing.
*/
tw32_mailbox(MAILBOX_INTERRUPT_0 + TG3_64BIT_REG_LOW, 0x00000001);
tw32_mailbox(tnapi->int_mbox, 0x00000001);
if (likely(!tg3_irq_sync(tp)))
napi_schedule(&tnapi->napi);
......@@ -8807,6 +8807,8 @@ static int tg3_reset_hw(struct tg3 *tp, int reset_phy)
if (tg3_flag(tp, USING_MSIX) && tp->irq_cnt > 1) {
val = tr32(MSGINT_MODE);
val |= MSGINT_MODE_MULTIVEC_EN | MSGINT_MODE_ENABLE;
if (!tg3_flag(tp, 1SHOT_MSI))
val |= MSGINT_MODE_ONE_SHOT_DISABLE;
tw32(MSGINT_MODE, val);
}
......@@ -9422,7 +9424,7 @@ static int tg3_test_interrupt(struct tg3 *tp)
if (intr_ok) {
/* Reenable MSI one shot mode. */
if (tg3_flag(tp, 57765_PLUS)) {
if (tg3_flag(tp, 57765_PLUS) && tg3_flag(tp, 1SHOT_MSI)) {
val = tr32(MSGINT_MODE) & ~MSGINT_MODE_ONE_SHOT_DISABLE;
tw32(MSGINT_MODE, val);
}
......@@ -9600,6 +9602,8 @@ static void tg3_ints_init(struct tg3 *tp)
u32 msi_mode = tr32(MSGINT_MODE);
if (tg3_flag(tp, USING_MSIX) && tp->irq_cnt > 1)
msi_mode |= MSGINT_MODE_MULTIVEC_EN;
if (!tg3_flag(tp, 1SHOT_MSI))
msi_mode |= MSGINT_MODE_ONE_SHOT_DISABLE;
tw32(MSGINT_MODE, msi_mode | MSGINT_MODE_ENABLE);
}
defcfg:
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment