net: phy: dp83867: fix irq generation

[ Upstream commit 5ca7d1ca ]

For proper IRQ generation by DP83867 phy the INT/PWDN pin has to be
programmed as an interrupt output instead of a Powerdown input in
Configuration Register 3 (CFG3), Address 0x001E, bit 7 INT_OE = 1. The
current driver doesn't do this and as result IRQs will not be generated by
DP83867 phy even if they are properly configured in DT.

Hence, fix IRQ generation by properly configuring CFG3.INT_OE bit and
ensure that Link Status Change (LINK_STATUS_CHNG_INT) and Auto-Negotiation
Complete (AUTONEG_COMP_INT) interrupt are enabled. After this the DP83867
driver will work properly in interrupt enabled mode.
Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com>
Reviewed-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Signed-off-by: Sasha Levin <alexander.levin@verizon.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/net/phy/dp83867.c

@@ -29,6 +29,7 @@
 #define MII_DP83867_MICR	0x12
 #define MII_DP83867_ISR		0x13
 #define DP83867_CTRL		0x1f
+#define DP83867_CFG3		0x1e
 
 /* Extended Registers */
 #define DP83867_RGMIICTL	0x0032
@@ -90,6 +91,8 @@ static int dp83867_config_intr(struct phy_device *phydev)
 		micr_status |=
 			(MII_DP83867_MICR_AN_ERR_INT_EN |
 			MII_DP83867_MICR_SPEED_CHNG_INT_EN |
+			MII_DP83867_MICR_AUTONEG_COMP_INT_EN |
+			MII_DP83867_MICR_LINK_STS_CHNG_INT_EN |
 			MII_DP83867_MICR_DUP_MODE_CHNG_INT_EN |
 			MII_DP83867_MICR_SLEEP_MODE_CHNG_INT_EN);
 
@@ -190,6 +193,13 @@ static int dp83867_config_init(struct phy_device *phydev)
 				       DP83867_DEVADDR, delay);
 	}
 
+	/* Enable Interrupt output INT_OE in CFG3 register */
+	if (phy_interrupt_is_valid(phydev)) {
+		val = phy_read(phydev, DP83867_CFG3);
+		val |= BIT(7);
+		phy_write(phydev, DP83867_CFG3, val);
+	}
+
 	return 0;
 }