Commit 638c133e authored by Bjorn Helgaas's avatar Bjorn Helgaas

PCI/PM: Revert "PCI/PM: Apply D2 delay as milliseconds, not microseconds"

This reverts commit 7e24bc34.

7e24bc34 was based on PCIe r5.0, sec 5.9, which claims we need a 200 ms
delay when transitioning to or from D2.  However, sec 5.3.1.3 states the
delay as 200 μs (microseconds), as does the table in PCIe r4.0, sec 5.9.1.

This looks like a typo in the r5.0 spec, so revert back to a 200 μs delay
instead of a 200 ms delay.

Fixes: 7e24bc34 ("PCI/PM: Apply D2 delay as milliseconds, not microseconds")
Signed-off-by: default avatarBjorn Helgaas <bhelgaas@google.com>
Reviewed-by: default avatarRafael J. Wysocki <rafael.j.wysocki@intel.com>
parent 454d082d
......@@ -1065,7 +1065,7 @@ static int pci_raw_set_power_state(struct pci_dev *dev, pci_power_t state)
if (state == PCI_D3hot || dev->current_state == PCI_D3hot)
pci_dev_d3_sleep(dev);
else if (state == PCI_D2 || dev->current_state == PCI_D2)
msleep(PCI_PM_D2_DELAY);
udelay(PCI_PM_D2_DELAY);
pci_read_config_word(dev, dev->pm_cap + PCI_PM_CTRL, &pmcsr);
dev->current_state = (pmcsr & PCI_PM_CTRL_STATE_MASK);
......
......@@ -43,9 +43,9 @@ int pci_probe_reset_function(struct pci_dev *dev);
int pci_bridge_secondary_bus_reset(struct pci_dev *dev);
int pci_bus_error_reset(struct pci_dev *dev);
#define PCI_PM_D2_DELAY 200
#define PCI_PM_D3HOT_WAIT 10
#define PCI_PM_D3COLD_WAIT 100
#define PCI_PM_D2_DELAY 200 /* usec; see PCIe r4.0, sec 5.9.1 */
#define PCI_PM_D3HOT_WAIT 10 /* msec */
#define PCI_PM_D3COLD_WAIT 100 /* msec */
/**
* struct pci_platform_pm_ops - Firmware PM callbacks
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment