ixgbe: fix Need to call pci_save_state after pci_restore_state

This patch adds a pci_save_state() call in ixgbe_resume() after
pci_restore_state(). A similar change was made in ixgbe_io_slot_reset()
that accommodates pci_restore_state() new behavior. This change makes
pci_restore_state() clear the saved_state flag This is necessary due
to a resent kernel change to pci_restore_state() so that it now clears
the saved_state flag of the device right after the device.s standard
configuration registers have been poplulated with the previously saved
values.
Signed-off-by: Don Skidmore <donald.c.skidmore@intel.com>
Acked-by: Peter P Waskiewicz Jr <peter.p.waskiewicz.jr@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ixgbe/ixgbe_main.c

@@ -4373,6 +4373,11 @@ static int ixgbe_resume(struct pci_dev *pdev)
 
 	pci_set_power_state(pdev, PCI_D0);
 	pci_restore_state(pdev);
+	/*
+	 * pci_restore_state clears dev->state_saved so call
+	 * pci_save_state to restore it.
+	 */
+	pci_save_state(pdev);
 
 	err = pci_enable_device_mem(pdev);
 	if (err) {