drm: Schedule the output_poll_work with 1s delay if we have delayed event

Instead of scheduling the work to handle the initial delayed event, use 1s
delay.

This delay should not be needed, but Optimus/nouveau will fail in a
mysterious way if the delayed event is handled as soon as possible like it
is done in drm_helper_probe_single_connector_modes() in case the poll
was enabled before.

Reverting 339fd362 would give back the 10 sec (!) delay to handle the
delayed event. Adding 1sec delay to the poll_work is enough to work around
the issue in Optimus setups and gives shorter response on handling the
initial delayed event.

Fixes: 339fd362 ("drm: drm_probe_helper: Fix output_poll_work scheduling")
Cc: stable@vger.kernel.org   # v4.9
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
[danvet: Add FIXME to the comment to make it stick out more.]
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
Link: http://patchwork.freedesktop.org/patch/msgid/20170109143158.21917-1-peter.ujfalusi@ti.com

drivers/gpu/drm/drm_probe_helper.c

@@ -143,8 +143,18 @@ void drm_kms_helper_poll_enable_locked(struct drm_device *dev)
 	}
 
 	if (dev->mode_config.delayed_event) {
+		/*
+		 * FIXME:
+		 *
+		 * Use short (1s) delay to handle the initial delayed event.
+		 * This delay should not be needed, but Optimus/nouveau will
+		 * fail in a mysterious way if the delayed event is handled as
+		 * soon as possible like it is done in
+		 * drm_helper_probe_single_connector_modes() in case the poll
+		 * was enabled before.
+		 */
 		poll = true;
-		delay = 0;
+		delay = HZ;
 	}
 
 	if (poll)