genirq: Wake up irq thread after action has been installed

The wake_up_process() of the new irq thread in __setup_irq() is too
early as the irqaction is not yet fully initialized especially
action->irq is not yet set. The interrupt thread might dereference the
wrong irq descriptor.

Move the wakeup after the action is installed and action->irq has been
set.
Reported-by: Michael Buesch <mb@bu3sch.de>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Tested-by: Michael Buesch <mb@bu3sch.de>

kernel/irq/manage.c

@@ -607,7 +607,6 @@ __setup_irq(unsigned int irq, struct irq_desc *desc, struct irqaction *new)
 		 */
 		get_task_struct(t);
 		new->thread = t;
-		wake_up_process(t);
 	}
 
 	/*
@@ -690,6 +689,7 @@ __setup_irq(unsigned int irq, struct irq_desc *desc, struct irqaction *new)
 				(int)(new->flags & IRQF_TRIGGER_MASK));
 	}
 
+	new->irq = irq;
 	*old_ptr = new;
 
 	/* Reset broken irq detection when installing new handler */
@@ -707,7 +707,13 @@ __setup_irq(unsigned int irq, struct irq_desc *desc, struct irqaction *new)
 
 	spin_unlock_irqrestore(&desc->lock, flags);
 
-	new->irq = irq;
+	/*
+	 * Strictly no need to wake it up, but hung_task complains
+	 * when no hard interrupt wakes the thread up.
+	 */
+	if (new->thread)
+		wake_up_process(new->thread);
+
 	register_irq_proc(irq, desc);
 	new->dir = NULL;
 	register_handler_proc(irq, new);