ixgbe: restore offloaded SAs after a reset

On a chip reset most of the table contents are lost, so must be
restored.  This scans the driver's ipsec tables and restores both
the filled and empty table slots to their pre-reset values.
Signed-off-by: Shannon Nelson <shannon.nelson@oracle.com>
Tested-by: Andrew Bowers <andrewx.bowers@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/ixgbe/ixgbe.h

@@ -1020,8 +1020,10 @@ s32 ixgbe_negotiate_fc(struct ixgbe_hw *hw, u32 adv_reg, u32 lp_reg,
 #ifdef CONFIG_XFRM_OFFLOAD
 void ixgbe_init_ipsec_offload(struct ixgbe_adapter *adapter);
 void ixgbe_stop_ipsec_offload(struct ixgbe_adapter *adapter);
+void ixgbe_ipsec_restore(struct ixgbe_adapter *adapter);
 #else
 static inline void ixgbe_init_ipsec_offload(struct ixgbe_adapter *adapter) { };
 static inline void ixgbe_stop_ipsec_offload(struct ixgbe_adapter *adapter) { };
+static inline void ixgbe_ipsec_restore(struct ixgbe_adapter *adapter) { };
 #endif /* CONFIG_XFRM_OFFLOAD */
 #endif /* _IXGBE_H_ */

drivers/net/ethernet/intel/ixgbe/ixgbe_ipsec.c

@@ -298,6 +298,47 @@ static void ixgbe_ipsec_start_engine(struct ixgbe_adapter *adapter)
 	IXGBE_WRITE_FLUSH(hw);
 }
 
+/**
+ * ixgbe_ipsec_restore - restore the ipsec HW settings after a reset
+ * @adapter: board private structure
+ **/
+void ixgbe_ipsec_restore(struct ixgbe_adapter *adapter)
+{
+	struct ixgbe_ipsec *ipsec = adapter->ipsec;
+	struct ixgbe_hw *hw = &adapter->hw;
+	int i;
+
+	if (!(adapter->flags2 & IXGBE_FLAG2_IPSEC_ENABLED))
+		return;
+
+	/* clean up and restart the engine */
+	ixgbe_ipsec_stop_engine(adapter);
+	ixgbe_ipsec_clear_hw_tables(adapter);
+	ixgbe_ipsec_start_engine(adapter);
+
+	/* reload the IP addrs */
+	for (i = 0; i < IXGBE_IPSEC_MAX_RX_IP_COUNT; i++) {
+		struct rx_ip_sa *ipsa = &ipsec->ip_tbl[i];
+
+		if (ipsa->used)
+			ixgbe_ipsec_set_rx_ip(hw, i, ipsa->ipaddr);
+	}
+
+	/* reload the Rx and Tx keys */
+	for (i = 0; i < IXGBE_IPSEC_MAX_SA_COUNT; i++) {
+		struct rx_sa *rsa = &ipsec->rx_tbl[i];
+		struct tx_sa *tsa = &ipsec->tx_tbl[i];
+
+		if (rsa->used)
+			ixgbe_ipsec_set_rx_sa(hw, i, rsa->xs->id.spi,
+					      rsa->key, rsa->salt,
+					      rsa->mode, rsa->iptbl_ind);
+
+		if (tsa->used)
+			ixgbe_ipsec_set_tx_sa(hw, i, tsa->key, tsa->salt);
+	}
+}
+
 /**
  * ixgbe_ipsec_find_empty_idx - find the first unused security parameter index
  * @ipsec: pointer to ipsec struct

drivers/net/ethernet/intel/ixgbe/ixgbe_main.c

@@ -5425,6 +5425,7 @@ static void ixgbe_configure(struct ixgbe_adapter *adapter)
 
 	ixgbe_set_rx_mode(adapter->netdev);
 	ixgbe_restore_vlan(adapter);
+	ixgbe_ipsec_restore(adapter);
 
 	switch (hw->mac.type) {
 	case ixgbe_mac_82599EB: