ath10k: add QCA9377 sdio hw_param item

Add hardware parameters for QCA9377 sdio devices, it's now properly supported.
Signed-off-by: Erik Stromdahl <erik.stromdahl@gmail.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

drivers/net/wireless/ath/ath10k/core.c

@@ -540,6 +540,33 @@ static const struct ath10k_hw_params ath10k_hw_params_list[] = {
 		.fw_diag_ce_download = true,
 		.tx_stats_over_pktlog = false,
 	},
+	{
+		.id = QCA9377_HW_1_1_DEV_VERSION,
+		.dev_id = QCA9377_1_0_DEVICE_ID,
+		.bus = ATH10K_BUS_SDIO,
+		.name = "qca9377 hw1.1 sdio",
+		.patch_load_addr = QCA9377_HW_1_0_PATCH_LOAD_ADDR,
+		.uart_pin = 19,
+		.otp_exe_param = 0,
+		.channel_counters_freq_hz = 88000,
+		.max_probe_resp_desc_thres = 0,
+		.cal_data_len = 8124,
+		.fw = {
+			.dir = QCA9377_HW_1_0_FW_DIR,
+			.board = QCA9377_HW_1_0_BOARD_DATA_FILE,
+			.board_size = QCA9377_BOARD_DATA_SZ,
+			.board_ext_size = QCA9377_BOARD_EXT_DATA_SZ,
+		},
+		.hw_ops = &qca6174_ops,
+		.hw_clk = qca6174_clk,
+		.target_cpu_freq = 176000000,
+		.decap_align_bytes = 4,
+		.n_cipher_suites = 8,
+		.num_peers = TARGET_QCA9377_HL_NUM_PEERS,
+		.ast_skid_limit = 0x10,
+		.num_wds_entries = 0x20,
+		.uart_pin_workaround = true,
+	},
 	{
 		.id = QCA4019_HW_1_0_DEV_VERSION,
 		.dev_id = 0,

drivers/net/wireless/ath/ath10k/hw.h

@@ -774,6 +774,9 @@ ath10k_is_rssi_enable(struct ath10k_hw_params *hw,
 #define TARGET_HL_TLV_AST_SKID_LIMIT		16
 #define TARGET_HL_TLV_NUM_WDS_ENTRIES		2
 
+/* Target specific defines for QCA9377 high latency firmware */
+#define TARGET_QCA9377_HL_NUM_PEERS		15
+
 /* Diagnostic Window */
 #define CE_DIAG_PIPE	7