Merge series "spi: meson-spicc: add support for AXG and G12A variants" from...

Merge series "spi: meson-spicc: add support for AXG and G12A variants" from Neil Armstrong <narmstrong@baylibre.com>:

The SPICC controller in Amlogic AXG & G12A is capable of driving the
CLK/MOSI/SS signal lines through the idle state which avoid the signals
floating in unexpected state, is capable of using linear clock divider
to reach a much fine tuned range of clocks, while the old controller only
uses a power of two clock divider, result at a more coarse clock range and
finally is capable of running at 80M clock.

The SPICC controller in Amlogic G12A takes the source clock from a specific
clock instead of the bus clock and has a different FIFO size and doesn't
handle the RX Half interrupt the same way as GXL & AXG variants. Thus
the burst management is simplified and takes in account a variable FIFO
size.

Now the controller can support frequencies higher than 30MHz, we need
the setup the I/O line delays in regard of the SPI clock frequency.

Neil Armstrong (7):
  spi: meson-spicc: remove unused variables
  spi: meson-spicc: support max 80MHz clock
  spi: meson-spicc: add min sclk for each compatible
  spi: meson-spicc: setup IO line delay
  spi: meson-spicc: adapt burst handling for G12A support
  dt-bindings: spi: amlogic,meson-gx-spicc: add Amlogic G12A compatible
  spi: meson-spicc: add support for Amlogic G12A

Sunny Luo (2):
  spi: meson-spicc: enhance output enable feature
  spi: meson-spicc: add a linear clock divider support

 .../bindings/spi/amlogic,meson-gx-spicc.yaml  |  22 +
 drivers/spi/Kconfig                           |   1 +
 drivers/spi/spi-meson-spicc.c                 | 496 +++++++++++++-----
 3 files changed, 392 insertions(+), 127 deletions(-)

--
2.22.0

_______________________________________________
linux-amlogic mailing list
linux-amlogic@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-amlogic

Documentation/devicetree/bindings/spi/amlogic,meson-gx-spicc.yaml

@@ -22,6 +22,7 @@ properties:
     enum:
       - amlogic,meson-gx-spicc # SPICC controller on Amlogic GX and compatible SoCs
       - amlogic,meson-axg-spicc # SPICC controller on Amlogic AXG and compatible SoCs
+      - amlogic,meson-g12a-spicc # SPICC controller on Amlogic G12A and compatible SoCs
 
   interrupts:
     maxItems: 1
@@ -40,6 +41,27 @@ properties:
     items:
       - const: core
 
+if:
+  properties:
+    compatible:
+      contains:
+        enum:
+          - amlogic,meson-g12a-spicc
+
+then:
+  properties:
+    clocks:
+      contains:
+        items:
+          - description: controller register bus clock
+          - description: baud rate generator and delay control clock
+
+    clock-names:
+      minItems: 2
+      items:
+        - const: core
+        - const: pclk
+
 required:
   - compatible
   - reg

drivers/spi/Kconfig

@@ -428,6 +428,7 @@ config SPI_FSL_ESPI
 
 config SPI_MESON_SPICC
 	tristate "Amlogic Meson SPICC controller"
+	depends on COMMON_CLK
 	depends on ARCH_MESON || COMPILE_TEST
 	help
 	  This enables master mode support for the SPICC (SPI communication