Merge branch 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input

Pull input subsystem fixes from Dmitry Torokhov:
 "Just a few driver fixes."

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input:
  Input: tsc40 - remove wrong announcement of pressure support
  Input: lpc32xx-keys - select INPUT_MATRIXKMAP
  Input: pxa27x_keypad - clear pending interrupts on keypad config
  Input: wacom - correct bad Cintiq 24HD check
  Input: wacom - add INPUT_PROP_DIRECT flag to Cintiq 24HD
  Input: egalax_ts - get gpio from devicetree

Documentation/devicetree/bindings/input/touchscreen/egalax-ts.txt

+* EETI eGalax Multiple Touch Controller
+
+Required properties:
+- compatible: must be "eeti,egalax_ts"
+- reg: i2c slave address
+- interrupt-parent: the phandle for the interrupt controller
+- interrupts: touch controller interrupt
+- wakeup-gpios: the gpio pin to be used for waking up the controller
+  as well as uased as irq pin
+
+Example:
+
+	egalax_ts@04 {
+		compatible = "eeti,egalax_ts";
+		reg = <0x04>;
+		interrupt-parent = <&gpio1>;
+		interrupts = <9 2>;
+		wakeup-gpios = <&gpio1 9 0>;
+	};

drivers/input/keyboard/Kconfig

@@ -335,6 +335,7 @@ config KEYBOARD_LOCOMO
 config KEYBOARD_LPC32XX
 	tristate "LPC32XX matrix key scanner support"
 	depends on ARCH_LPC32XX && OF
+	select INPUT_MATRIXKMAP
 	help
 	  Say Y here if you want to use NXP LPC32XX SoC key scanner interface,
 	  connected to a key matrix.

drivers/input/keyboard/pxa27x_keypad.c

@@ -368,6 +368,9 @@ static void pxa27x_keypad_config(struct pxa27x_keypad *keypad)
 	unsigned int mask = 0, direct_key_num = 0;
 	unsigned long kpc = 0;
 
+	/* clear pending interrupt bit */
+	keypad_readl(KPC);
+
 	/* enable matrix keys with automatic scan */
 	if (pdata->matrix_key_rows && pdata->matrix_key_cols) {
 		kpc |= KPC_ASACT | KPC_MIE | KPC_ME | KPC_MS_ALL;

drivers/input/tablet/wacom_sys.c

@@ -391,7 +391,7 @@ static int wacom_parse_hid(struct usb_interface *intf,
 							features->pktlen = WACOM_PKGLEN_TPC2FG;
 						}
 
-						if (features->type == MTSCREEN || WACOM_24HDT)
+						if (features->type == MTSCREEN || features->type == WACOM_24HDT)
 							features->pktlen = WACOM_PKGLEN_MTOUCH;
 
 						if (features->type == BAMBOO_PT) {

drivers/input/tablet/wacom_wac.c

@@ -1518,6 +1518,9 @@ int wacom_setup_input_capabilities(struct input_dev *input_dev,
 
 		input_set_abs_params(input_dev, ABS_Z, -900, 899, 0, 0);
 		input_set_abs_params(input_dev, ABS_THROTTLE, 0, 71, 0, 0);
+
+		__set_bit(INPUT_PROP_DIRECT, input_dev->propbit);
+
 		wacom_setup_cintiq(wacom_wac);
 		break;
 

drivers/input/touchscreen/Kconfig

@@ -239,7 +239,7 @@ config TOUCHSCREEN_EETI
 
 config TOUCHSCREEN_EGALAX
 	tristate "EETI eGalax multi-touch panel support"
-	depends on I2C
+	depends on I2C && OF
 	help
 	  Say Y here to enable support for I2C connected EETI
 	  eGalax multi-touch panels.

drivers/input/touchscreen/egalax_ts.c

@@ -28,6 +28,7 @@
 #include <linux/slab.h>
 #include <linux/bitops.h>
 #include <linux/input/mt.h>
+#include <linux/of_gpio.h>
 
 /*
  * Mouse Mode: some panel may configure the controller to mouse mode,
@@ -122,9 +123,17 @@ static irqreturn_t egalax_ts_interrupt(int irq, void *dev_id)
 /* wake up controller by an falling edge of interrupt gpio.  */
 static int egalax_wake_up_device(struct i2c_client *client)
 {
-	int gpio = irq_to_gpio(client->irq);
+	struct device_node *np = client->dev.of_node;
+	int gpio;
 	int ret;
 
+	if (!np)
+		return -ENODEV;
+
+	gpio = of_get_named_gpio(np, "wakeup-gpios", 0);
+	if (!gpio_is_valid(gpio))
+		return -ENODEV;
+
 	ret = gpio_request(gpio, "egalax_irq");
 	if (ret < 0) {
 		dev_err(&client->dev,
@@ -181,7 +190,11 @@ static int __devinit egalax_ts_probe(struct i2c_client *client,
 	ts->input_dev = input_dev;
 
 	/* controller may be in sleep, wake it up. */
-	egalax_wake_up_device(client);
+	error = egalax_wake_up_device(client);
+	if (error) {
+		dev_err(&client->dev, "Failed to wake up the controller\n");
+		goto err_free_dev;
+	}
 
 	ret = egalax_firmware_version(client);
 	if (ret < 0) {
@@ -274,11 +287,17 @@ static int egalax_ts_resume(struct device *dev)
 
 static SIMPLE_DEV_PM_OPS(egalax_ts_pm_ops, egalax_ts_suspend, egalax_ts_resume);
 
+static struct of_device_id egalax_ts_dt_ids[] = {
+	{ .compatible = "eeti,egalax_ts" },
+	{ /* sentinel */ }
+};
+
 static struct i2c_driver egalax_ts_driver = {
 	.driver = {
 		.name	= "egalax_ts",
 		.owner	= THIS_MODULE,
 		.pm	= &egalax_ts_pm_ops,
+		.of_match_table	= of_match_ptr(egalax_ts_dt_ids),
 	},
 	.id_table	= egalax_ts_id,
 	.probe		= egalax_ts_probe,

drivers/input/touchscreen/tsc40.c

@@ -107,7 +107,6 @@ static int tsc_connect(struct serio *serio, struct serio_driver *drv)
 	__set_bit(BTN_TOUCH, input_dev->keybit);
 	input_set_abs_params(ptsc->dev, ABS_X, 0, 0x3ff, 0, 0);
 	input_set_abs_params(ptsc->dev, ABS_Y, 0, 0x3ff, 0, 0);
-	input_set_abs_params(ptsc->dev, ABS_PRESSURE, 0, 0, 0, 0);
 
 	serio_set_drvdata(serio, ptsc);