ARM: msm: Update the references to DEBUG_MSM_UARTx

The Kconfig options DEBUG_MSM_UART1, DEBUG_MSM_UART2, DEBUG_MSM_UART3,
MSM_DEBUG_UART1, MSM_DEBUG_UART2 and MSM_DEBUG_UART3 are removed, but
they are still referenced in the following files:
	arch/arm/mach-msm/io.c,
	arch/arm/mach-msm/board-trout.c
	arch/arm/mach-msm/board-trout-gpio.c

Fix this by updating the reference to the new Kconfig option.
Reported-by: Paul Bolle <pebolle@tiscali.nl>
Signed-off-by: Georgi Djakov <gdjakov@mm-sol.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

arch/arm/mach-msm/board-trout-gpio.c

@@ -94,7 +94,7 @@ static int trout_gpio_to_irq(struct gpio_chip *chip, unsigned offset)
 	}
 
 static struct msm_gpio_chip msm_gpio_banks[] = {
-#if defined(CONFIG_MSM_DEBUG_UART1)
+#if defined(CONFIG_DEBUG_MSM_UART) && (CONFIG_DEBUG_UART_PHYS == 0xa9a00000)
 	/* H2W pins <-> UART1 */
 	TROUT_GPIO_BANK("MISC2", 0x00,   TROUT_GPIO_MISC2_BASE, 0x40),
 #else

arch/arm/mach-msm/board-trout.c

@@ -88,7 +88,7 @@ static void __init trout_map_io(void)
 	msm_map_common_io();
 	iotable_init(trout_io_desc, ARRAY_SIZE(trout_io_desc));
 
-#ifdef CONFIG_MSM_DEBUG_UART3
+#if defined(CONFIG_DEBUG_MSM_UART) && (CONFIG_DEBUG_UART_PHYS == 0xa9c00000)
 	/* route UART3 to the "H2W" extended usb connector */
 	writeb(0x80, TROUT_CPLD_BASE + 0x00);
 #endif

arch/arm/mach-msm/io.c

@@ -57,8 +57,7 @@ static struct map_desc msm_io_desc[] __initdata = {
 		.length =   MSM_SHARED_RAM_SIZE,
 		.type =     MT_DEVICE,
 	},
-#if defined(CONFIG_DEBUG_MSM_UART1) || defined(CONFIG_DEBUG_MSM_UART2) || \
-		defined(CONFIG_DEBUG_MSM_UART3)
+#if defined(CONFIG_DEBUG_MSM_UART)
 	{
 		/* Must be last: virtual and pfn filled in by debug_ll_addr() */
 		.length = SZ_4K,
@@ -76,8 +75,7 @@ void __init msm_map_common_io(void)
 	 * pages are peripheral interface or not.
 	 */
 	asm("mcr p15, 0, %0, c15, c2, 4" : : "r" (0));
-#if defined(CONFIG_DEBUG_MSM_UART1) || defined(CONFIG_DEBUG_MSM_UART2) || \
-		defined(CONFIG_DEBUG_MSM_UART3)
+#if defined(CONFIG_DEBUG_MSM_UART)
 #ifdef CONFIG_MMU
 	debug_ll_addr(&msm_io_desc[size - 1].pfn,
 		      &msm_io_desc[size - 1].virtual);