xhci: use default USB_RESUME_TIMEOUT when resuming ports.

USB2 host inititated resume, and system suspend bus resume
need to use the same USB_RESUME_TIMEOUT as elsewhere.

This resolves a device disconnect issue at system resume seen
on Intel Braswell and Apollolake, but is in no way limited to
those platforms.
Signed-off-by: Mathias Nyman <mathias.nyman@linux.intel.com>
CC: <stable@vger.kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/usb/host/xhci-hub.c

@@ -1166,7 +1166,7 @@ int xhci_hub_control(struct usb_hcd *hcd, u16 typeReq, u16 wValue,
 				xhci_set_link_state(xhci, port_array, wIndex,
 							XDEV_RESUME);
 				spin_unlock_irqrestore(&xhci->lock, flags);
-				msleep(20);
+				msleep(USB_RESUME_TIMEOUT);
 				spin_lock_irqsave(&xhci->lock, flags);
 				xhci_set_link_state(xhci, port_array, wIndex,
 							XDEV_U0);
@@ -1447,7 +1447,7 @@ int xhci_bus_resume(struct usb_hcd *hcd)
 
 	if (need_usb2_u3_exit) {
 		spin_unlock_irqrestore(&xhci->lock, flags);
-		msleep(20);
+		msleep(USB_RESUME_TIMEOUT);
 		spin_lock_irqsave(&xhci->lock, flags);
 	}