block: move bd_set_size() above rescan_partitions() in __blkdev_get()

02e35228 (block: rescan partitions on invalidated devices on
-ENOMEDIA too) relocated partition rescan above explicit bd_set_size()
to simplify condition check.  As rescan_partitions() does its own bdev
size setting, this doesn't break anything; however,
rescan_partitions() prints out the following messages when adjusting
bdev size, which can be confusing.

  sda: detected capacity change from 0 to 146815737856
  sdb: detected capacity change from 0 to 146815737856

This patch restores the original order and remove the warning
messages.

stable: Please apply together with 02e35228 (block: rescan
        partitions on invalidated devices on -ENOMEDIA too).
Signed-off-by: Tejun Heo <tj@kernel.org>
Reported-by: Tony Luck <tony.luck@gmail.com>
Tested-by: Tony Luck <tony.luck@gmail.com>
Cc: stable@kernel.org

Stable note: 2.6.39 only.
Signed-off-by: Jens Axboe <jaxboe@fusionio.com>

fs/block_dev.c

@@ -1120,6 +1120,15 @@ static int __blkdev_get(struct block_device *bdev, fmode_t mode, int for_part)
 					goto restart;
 				}
 			}
+
+			if (!ret && !bdev->bd_openers) {
+				bd_set_size(bdev,(loff_t)get_capacity(disk)<<9);
+				bdi = blk_get_backing_dev_info(bdev);
+				if (bdi == NULL)
+					bdi = &default_backing_dev_info;
+				bdev_inode_switch_bdi(bdev->bd_inode, bdi);
+			}
+
 			/*
 			 * If the device is invalidated, rescan partition
 			 * if open succeeded or failed with -ENOMEDIUM.
@@ -1130,14 +1139,6 @@ static int __blkdev_get(struct block_device *bdev, fmode_t mode, int for_part)
 				rescan_partitions(disk, bdev);
 			if (ret)
 				goto out_clear;
-
-			if (!bdev->bd_openers) {
-				bd_set_size(bdev,(loff_t)get_capacity(disk)<<9);
-				bdi = blk_get_backing_dev_info(bdev);
-				if (bdi == NULL)
-					bdi = &default_backing_dev_info;
-				bdev_inode_switch_bdi(bdev->bd_inode, bdi);
-			}
 		} else {
 			struct block_device *whole;
 			whole = bdget_disk(disk, 0);