e1000e: Use skb_copy_to_linear_data_offset introduced in 2.6.22

The e1000e driver was based on a version of e1000 prior to acme's
introduction of skb_copy_to_linear_data_offset, and was submitted
after acme went through and coverted all the drivers to use it.
Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

drivers/net/e1000e/netdev.c

@@ -510,9 +510,12 @@ static bool e1000_clean_rx_irq(struct e1000_adapter *adapter,
 			    netdev_alloc_skb(netdev, length + NET_IP_ALIGN);
 			if (new_skb) {
 				skb_reserve(new_skb, NET_IP_ALIGN);
-				memcpy(new_skb->data - NET_IP_ALIGN,
-				       skb->data - NET_IP_ALIGN,
-				       length + NET_IP_ALIGN);
+				skb_copy_to_linear_data_offset(new_skb,
+							       -NET_IP_ALIGN,
+							       (skb->data -
+								NET_IP_ALIGN),
+							       (length +
+								NET_IP_ALIGN));
 				/* save the skb in buffer_info as good */
 				buffer_info->skb = skb;
 				skb = new_skb;