mmc: sdhci: fix wakeup configuration

Activating wakeup event is not enough to get a wakeup signal. The
corresponding events have to be enabled in the Interrupt Status Enable
Register too. It follows the specification and is needed at least by
sdhci-of-at91.
Signed-off-by: Ludovic Desroches <ludovic.desroches@atmel.com>
Acked-by: Adrian Hunter <adrian.hunter@intel.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

drivers/mmc/host/sdhci.c

@@ -2605,18 +2605,31 @@ static irqreturn_t sdhci_thread_irq(int irq, void *dev_id)
 \*****************************************************************************/
 
 #ifdef CONFIG_PM
+/*
+ * To enable wakeup events, the corresponding events have to be enabled in
+ * the Interrupt Status Enable register too. See 'Table 1-6: Wakeup Signal
+ * Table' in the SD Host Controller Standard Specification.
+ * It is useless to restore SDHCI_INT_ENABLE state in
+ * sdhci_disable_irq_wakeups() since it will be set by
+ * sdhci_enable_card_detection() or sdhci_init().
+ */
 void sdhci_enable_irq_wakeups(struct sdhci_host *host)
 {
 	u8 val;
 	u8 mask = SDHCI_WAKE_ON_INSERT | SDHCI_WAKE_ON_REMOVE
 			| SDHCI_WAKE_ON_INT;
+	u32 irq_val = SDHCI_INT_CARD_INSERT | SDHCI_INT_CARD_REMOVE |
+		      SDHCI_INT_CARD_INT;
 
 	val = sdhci_readb(host, SDHCI_WAKE_UP_CONTROL);
 	val |= mask ;
 	/* Avoid fake wake up */
-	if (host->quirks & SDHCI_QUIRK_BROKEN_CARD_DETECTION)
+	if (host->quirks & SDHCI_QUIRK_BROKEN_CARD_DETECTION) {
 		val &= ~(SDHCI_WAKE_ON_INSERT | SDHCI_WAKE_ON_REMOVE);
+		irq_val &= ~(SDHCI_INT_CARD_INSERT | SDHCI_INT_CARD_REMOVE);
+	}
 	sdhci_writeb(host, val, SDHCI_WAKE_UP_CONTROL);
+	sdhci_writel(host, irq_val, SDHCI_INT_ENABLE);
 }
 EXPORT_SYMBOL_GPL(sdhci_enable_irq_wakeups);