Commit 877f1a7c authored by Sean Young's avatar Sean Young Committed by Mauro Carvalho Chehab

media: rc: mceusb: allow the timeout to be configurable

mceusb devices have a default timeout of 100ms, but this can be changed.
Signed-off-by: default avatarSean Young <sean@mess.org>
Signed-off-by: default avatarMauro Carvalho Chehab <mchehab@s-opensource.com>
parent 91352b57
...@@ -982,6 +982,25 @@ static int mceusb_set_tx_carrier(struct rc_dev *dev, u32 carrier) ...@@ -982,6 +982,25 @@ static int mceusb_set_tx_carrier(struct rc_dev *dev, u32 carrier)
return 0; return 0;
} }
static int mceusb_set_timeout(struct rc_dev *dev, unsigned int timeout)
{
u8 cmdbuf[4] = { MCE_CMD_PORT_IR, MCE_CMD_SETIRTIMEOUT, 0, 0 };
struct mceusb_dev *ir = dev->priv;
unsigned int units;
units = DIV_ROUND_CLOSEST(timeout, US_TO_NS(MCE_TIME_UNIT));
cmdbuf[2] = units >> 8;
cmdbuf[3] = units;
mce_async_out(ir, cmdbuf, sizeof(cmdbuf));
/* get receiver timeout value */
mce_async_out(ir, GET_RX_TIMEOUT, sizeof(GET_RX_TIMEOUT));
return 0;
}
/* /*
* Select or deselect the 2nd receiver port. * Select or deselect the 2nd receiver port.
* Second receiver is learning mode, wide-band, short-range receiver. * Second receiver is learning mode, wide-band, short-range receiver.
...@@ -1420,7 +1439,10 @@ static struct rc_dev *mceusb_init_rc_dev(struct mceusb_dev *ir) ...@@ -1420,7 +1439,10 @@ static struct rc_dev *mceusb_init_rc_dev(struct mceusb_dev *ir)
rc->dev.parent = dev; rc->dev.parent = dev;
rc->priv = ir; rc->priv = ir;
rc->allowed_protocols = RC_PROTO_BIT_ALL_IR_DECODER; rc->allowed_protocols = RC_PROTO_BIT_ALL_IR_DECODER;
rc->min_timeout = US_TO_NS(MCE_TIME_UNIT);
rc->timeout = MS_TO_NS(100); rc->timeout = MS_TO_NS(100);
rc->max_timeout = 10 * IR_DEFAULT_TIMEOUT;
rc->s_timeout = mceusb_set_timeout;
if (!ir->flags.no_tx) { if (!ir->flags.no_tx) {
rc->s_tx_mask = mceusb_set_tx_mask; rc->s_tx_mask = mceusb_set_tx_mask;
rc->s_tx_carrier = mceusb_set_tx_carrier; rc->s_tx_carrier = mceusb_set_tx_carrier;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment