Commit 8c85f4b8 authored by Yoshihiro Shimoda's avatar Yoshihiro Shimoda Committed by David S. Miller

net: phy: micrel: add toggling phy reset if PHY is not attached

This patch adds toggling phy reset if PHY is not attached. Otherwise,
some boards (e.g. R-Car H3 Salvator-XS) cannot link up correctly if
we do the following method:

 1) Kernel boots by using initramfs.
 --> No open the nic, so phy_device_register() and phy_probe()
     deasserts the reset.
 2) Kernel enters the suspend.
 --> So, keep the reset signal as deassert.
 --> On R-Car Salvator-XS board, unfortunately, the board power is
     turned off.
 3) Kernel returns from suspend.
 4) ifconfig eth0 up
 --> Then, since edge signal of the reset doesn't happen,
     it cannot link up.
 5) ifconfig eth0 down
 6) ifconfig eth0 up
 --> In this case, it can link up.
Reported-by: default avatarHiromitsu Yamasaki <hiromitsu.yamasaki.ym@renesas.com>
Signed-off-by: default avatarYoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent ef1b5bf5
...@@ -23,6 +23,7 @@ ...@@ -23,6 +23,7 @@
* ksz9477 * ksz9477
*/ */
#include <linux/delay.h>
#include <linux/kernel.h> #include <linux/kernel.h>
#include <linux/module.h> #include <linux/module.h>
#include <linux/phy.h> #include <linux/phy.h>
...@@ -835,6 +836,13 @@ static int kszphy_resume(struct phy_device *phydev) ...@@ -835,6 +836,13 @@ static int kszphy_resume(struct phy_device *phydev)
{ {
int ret; int ret;
if (!phydev->attached_dev) {
/* If the PHY is not attached, toggle the reset */
phy_device_reset(phydev, 1);
udelay(1);
phy_device_reset(phydev, 0);
}
genphy_resume(phydev); genphy_resume(phydev);
ret = kszphy_config_reset(phydev); ret = kszphy_config_reset(phydev);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment