dt-bindings: power: supply: bq24190_charger: add bq24192 and usb-otg-vbus

Add support for the ti,bq24192 variant and a child node for the
usb-otg-vbus regulator.
Signed-off-by: Brian Masney <masneyb@onstation.org>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.com>

Documentation/devicetree/bindings/power/supply/bq24190.txt

@@ -3,6 +3,7 @@ TI BQ24190 Li-Ion Battery Charger
 Required properties:
 - compatible: contains one of the following:
     * "ti,bq24190"
+    * "ti,bq24192"
     * "ti,bq24192i"
 - reg: integer, I2C address of the charger.
 - interrupts[-extended]: configuration for charger INT pin.
@@ -19,6 +20,12 @@ Optional properties:
 - ti,system-minimum-microvolt: when power is connected and the battery is below
   minimum system voltage, the system will be regulated above this setting.
 
+child nodes:
+- usb-otg-vbus:
+  Usage: optional
+  Description: Regulator that is used to control the VBUS voltage direction for
+               either USB host mode or for charging on the OTG port.
+
 Notes:
 - Some circuit boards wire the chip's "OTG" pin high (enabling 500mA default
   charge current on USB SDP ports, among other features). To simulate this on
@@ -39,6 +46,8 @@ Example:
 		interrupts-extended = <&gpiochip 10 IRQ_TYPE_EDGE_FALLING>;
 		monitored-battery = <&bat>;
 		ti,system-minimum-microvolt = <3200000>;
+
+		usb_otg_vbus: usb-otg-vbus { };
 	};
 
 	&twl_gpio {