usb: chipidea: imx: allow to configure oc polarity on i.MX25

Up to now the polarity of the over current pin was hard coded to active
high. Use the already defined device tree properties to configure polarity
on i.MX25, too. In difference to i.MX6/7 use active high behavior if the
polarity is unspecified to keep compatibility to existing device trees.
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: Peter Chen <peter.chen@nxp.com>

drivers/usb/chipidea/usbmisc_imx.c

@@ -136,6 +136,14 @@ static int usbmisc_imx25_init(struct imx_usbmisc_data *data)
 		val &= ~(MX25_OTG_SIC_MASK | MX25_OTG_PP_BIT);
 		val |= (MX25_EHCI_INTERFACE_DIFF_UNI & MX25_EHCI_INTERFACE_MASK) << MX25_OTG_SIC_SHIFT;
 		val |= (MX25_OTG_PM_BIT | MX25_OTG_OCPOL_BIT);
+
+		/*
+		 * If the polarity is not configured assume active high for
+		 * historical reasons.
+		 */
+		if (data->oc_pol_configured && data->oc_pol_active_low)
+			val &= ~MX25_OTG_OCPOL_BIT;
+
 		writel(val, usbmisc->base);
 		break;
 	case 1:
@@ -145,6 +153,13 @@ static int usbmisc_imx25_init(struct imx_usbmisc_data *data)
 		val |= (MX25_H1_PM_BIT | MX25_H1_OCPOL_BIT | MX25_H1_TLL_BIT |
 			MX25_H1_USBTE_BIT | MX25_H1_IPPUE_DOWN_BIT);
 
+		/*
+		 * If the polarity is not configured assume active high for
+		 * historical reasons.
+		 */
+		if (data->oc_pol_configured && data->oc_pol_active_low)
+			val &= ~MX25_H1_OCPOL_BIT;
+
 		writel(val, usbmisc->base);
 
 		break;