Commit 94d66714 authored by Matthias Kaehlcke's avatar Matthias Kaehlcke Committed by Marcel Holtmann

Bluetooth: hci_qca: Reduce delay after sending baudrate request for WCN3990

The current 300ms delay after a baudrate change is extremely long.
For WCN3990 it is sufficient to wait 10ms after the baudrate change
request has been sent over the wire.
Signed-off-by: default avatarMatthias Kaehlcke <mka@chromium.org>
Signed-off-by: default avatarMarcel Holtmann <marcel@holtmann.org>
parent 5364a0b4
......@@ -59,8 +59,7 @@
#define IBS_WAKE_RETRANS_TIMEOUT_MS 100
#define IBS_TX_IDLE_TIMEOUT_MS 2000
#define BAUDRATE_SETTLE_TIMEOUT_MS 300
#define POWER_PULSE_TRANS_TIMEOUT_MS 100
#define CMD_TRANS_TIMEOUT_MS 100
/* susclk rate */
#define SUSCLK_RATE_32KHZ 32768
......@@ -964,6 +963,7 @@ static int qca_set_baudrate(struct hci_dev *hdev, uint8_t baudrate)
{
struct hci_uart *hu = hci_get_drvdata(hdev);
struct qca_data *qca = hu->priv;
struct qca_serdev *qcadev;
struct sk_buff *skb;
u8 cmd[] = { 0x01, 0x48, 0xFC, 0x01, 0x00 };
......@@ -985,11 +985,21 @@ static int qca_set_baudrate(struct hci_dev *hdev, uint8_t baudrate)
skb_queue_tail(&qca->txq, skb);
hci_uart_tx_wakeup(hu);
/* wait 300ms to change new baudrate on controller side
* controller will come back after they receive this HCI command
* then host can communicate with new baudrate to controller
*/
msleep(BAUDRATE_SETTLE_TIMEOUT_MS);
qcadev = serdev_device_get_drvdata(hu->serdev);
/* Wait for the baudrate change request to be sent */
while (!skb_queue_empty(&qca->txq))
usleep_range(100, 200);
serdev_device_wait_until_sent(hu->serdev,
msecs_to_jiffies(CMD_TRANS_TIMEOUT_MS));
/* Give the controller time to process the request */
if (qcadev->btsoc_type == QCA_WCN3990)
msleep(10);
else
msleep(300);
return 0;
}
......@@ -1005,7 +1015,7 @@ static inline void host_set_baudrate(struct hci_uart *hu, unsigned int speed)
static int qca_send_power_pulse(struct hci_uart *hu, bool on)
{
int ret;
int timeout = msecs_to_jiffies(POWER_PULSE_TRANS_TIMEOUT_MS);
int timeout = msecs_to_jiffies(CMD_TRANS_TIMEOUT_MS);
u8 cmd = on ? QCA_WCN3990_POWERON_PULSE : QCA_WCN3990_POWEROFF_PULSE;
/* These power pulses are single byte command which are sent
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment