irqchip/gic-v3: Configure all interrupts as non-secure Group-1

commit 7c9b9730 upstream.

The GICv3 driver wrongly assumes that it runs on the non-secure
side of a secure-enabled system, while it could be on a system
with a single security state, or a GICv3 with GICD_CTLR.DS set.

Either way, it is important to configure this properly, or
interrupts will simply not be delivered on this HW.
Reported-by: Peter Maydell <peter.maydell@linaro.org>
Tested-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Marc Zyngier <marc.zyngier@arm.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/irqchip/irq-gic-v3.c

@@ -387,6 +387,15 @@ static void __init gic_dist_init(void)
 	writel_relaxed(0, base + GICD_CTLR);
 	gic_dist_wait_for_rwp();
 
+	/*
+	 * Configure SPIs as non-secure Group-1. This will only matter
+	 * if the GIC only has a single security state. This will not
+	 * do the right thing if the kernel is running in secure mode,
+	 * but that's not the intended use case anyway.
+	 */
+	for (i = 32; i < gic_data.irq_nr; i += 32)
+		writel_relaxed(~0, base + GICD_IGROUPR + i / 8);
+
 	gic_dist_config(base, gic_data.irq_nr, gic_dist_wait_for_rwp);
 
 	/* Enable distributor with ARE, Group1 */
@@ -501,6 +510,9 @@ static void gic_cpu_init(void)
 
 	rbase = gic_data_rdist_sgi_base();
 
+	/* Configure SGIs/PPIs as non-secure Group-1 */
+	writel_relaxed(~0, rbase + GICR_IGROUPR0);
+
 	gic_cpu_config(rbase, gic_redist_wait_for_rwp);
 
 	/* Give LPIs a spin */