Commit 9b9344f7 authored by Mitch Williams's avatar Mitch Williams Committed by Jeff Kirsher

i40evf: set adapter state on reset failure

If a reset fails to complete, the driver gets its affairs in order and
awaits the cold solace of rmmod. Unfortunately, it was not properly
setting the adapter state, which would cause a panic on rmmod, instead
of the desired surcease.

Set the adapter state to DOWN in this case, and avoid a panic.

Change-ID: I6fdd9906da52e023f8dc744f7da44b5d95278ca9
Signed-off-by: default avatarMitch Williams <mitch.a.williams@intel.com>
Tested-by: default avatarAndrew Bowers <andrewx.bowers@intel.com>
Signed-off-by: default avatarJeff Kirsher <jeffrey.t.kirsher@intel.com>
parent 6e93d0c9
...@@ -1883,6 +1883,7 @@ static void i40evf_reset_task(struct work_struct *work) ...@@ -1883,6 +1883,7 @@ static void i40evf_reset_task(struct work_struct *work)
adapter->netdev->flags &= ~IFF_UP; adapter->netdev->flags &= ~IFF_UP;
clear_bit(__I40EVF_IN_CRITICAL_TASK, &adapter->crit_section); clear_bit(__I40EVF_IN_CRITICAL_TASK, &adapter->crit_section);
adapter->flags &= ~I40EVF_FLAG_RESET_PENDING; adapter->flags &= ~I40EVF_FLAG_RESET_PENDING;
adapter->state = __I40EVF_DOWN;
dev_info(&adapter->pdev->dev, "Reset task did not complete, VF disabled\n"); dev_info(&adapter->pdev->dev, "Reset task did not complete, VF disabled\n");
return; /* Do not attempt to reinit. It's dead, Jim. */ return; /* Do not attempt to reinit. It's dead, Jim. */
} }
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment