ixgbe: Drop RLPML configuration from x540 RXDCTL register configuration

Since we are doing a page based receive there is no point in setting a maximum
packet length on the x540 RXDCTL register.  As such we can drop the code from
the driver entirely.
Signed-off-by: Alexander Duyck <alexander.h.duyck@intel.com>
Tested-by: Phil Schmitt <phillip.j.schmitt@intel.com>
Tested-by: Marcus Dennis <marcusx.e.dennis@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/ixgbe/ixgbe_main.c

@@ -3170,14 +3170,6 @@ void ixgbe_configure_rx_ring(struct ixgbe_adapter *adapter,
 	ixgbe_configure_srrctl(adapter, ring);
 	ixgbe_configure_rscctl(adapter, ring);
 
-	/* If operating in IOV mode set RLPML for X540 */
-	if ((adapter->flags & IXGBE_FLAG_SRIOV_ENABLED) &&
-	    hw->mac.type == ixgbe_mac_X540) {
-		rxdctl &= ~IXGBE_RXDCTL_RLPMLMASK;
-		rxdctl |= ((ring->netdev->mtu + ETH_HLEN +
-			    ETH_FCS_LEN + VLAN_HLEN) | IXGBE_RXDCTL_RLPML_EN);
-	}
-
 	if (hw->mac.type == ixgbe_mac_82598EB) {
 		/*
 		 * enable cache line friendly hardware writes: