ARM: ux500: Set eMMC and WLAN card slot as non-removable

For several reasons, the mmc protocol layer expects devices
being non-removable to use MMC_CAP_NONREMOVABLE, so then we
adapt to this expectation.
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

arch/arm/mach-ux500/board-mop500-sdi.c

@@ -107,7 +107,8 @@ static struct stedma40_chan_cfg sdi1_dma_cfg_tx = {
 struct mmci_platform_data mop500_sdi1_data = {
 	.ocr_mask	= MMC_VDD_29_30,
 	.f_max		= 100000000,
-	.capabilities	= MMC_CAP_4_BIT_DATA,
+	.capabilities	= MMC_CAP_4_BIT_DATA |
+				MMC_CAP_NONREMOVABLE,
 	.gpio_cd	= -1,
 	.gpio_wp	= -1,
 #ifdef CONFIG_STE_DMA40
@@ -146,6 +147,7 @@ struct mmci_platform_data mop500_sdi2_data = {
 	.f_max		= 100000000,
 	.capabilities	= MMC_CAP_4_BIT_DATA |
 				MMC_CAP_8_BIT_DATA |
+				MMC_CAP_NONREMOVABLE |
 				MMC_CAP_MMC_HIGHSPEED |
 				MMC_CAP_ERASE |
 				MMC_CAP_CMD23,
@@ -186,6 +188,7 @@ struct mmci_platform_data mop500_sdi4_data = {
 	.f_max		= 100000000,
 	.capabilities	= MMC_CAP_4_BIT_DATA |
 				MMC_CAP_8_BIT_DATA |
+				MMC_CAP_NONREMOVABLE |
 				MMC_CAP_MMC_HIGHSPEED |
 				MMC_CAP_ERASE |
 				MMC_CAP_CMD23,