Commit a8a398b8 authored by Dilip Kota's avatar Dilip Kota Committed by Mark Brown

dt-bindings: soc: qcom: Remove SPI controller maximum frequency binding

SPI controller driver should maintain the maximum frequency
of the controller instead of relying on device tree bindings.
Because maximum frequency is specific property of SPI
controller.
Signed-off-by: default avatarDilip Kota <dkota@codeaurora.org>
Reviewed-by: default avatarDouglas Anderson <dianders@chromium.org>
Reviewed-by: default avatarStephen Boyd <swboyd@chromium.org>
Reviewed-by: default avatarRob Herring <robh@kernel.org>
Signed-off-by: default avatarAlok Chauhan <alokc@codeaurora.org>
Signed-off-by: default avatarMark Brown <broonie@kernel.org>
parent a3c17402
...@@ -60,7 +60,6 @@ Required properties: ...@@ -60,7 +60,6 @@ Required properties:
- interrupts: Must contain SPI controller interrupts. - interrupts: Must contain SPI controller interrupts.
- clock-names: Must contain "se". - clock-names: Must contain "se".
- clocks: Serial engine core clock needed by the device. - clocks: Serial engine core clock needed by the device.
- spi-max-frequency: Specifies maximum SPI clock frequency, units - Hz.
- #address-cells: Must be <1> to define a chip select address on - #address-cells: Must be <1> to define a chip select address on
the SPI bus. the SPI bus.
- #size-cells: Must be <0>. - #size-cells: Must be <0>.
...@@ -112,7 +111,6 @@ Example: ...@@ -112,7 +111,6 @@ Example:
pinctrl-names = "default", "sleep"; pinctrl-names = "default", "sleep";
pinctrl-0 = <&qup_1_spi_2_active>; pinctrl-0 = <&qup_1_spi_2_active>;
pinctrl-1 = <&qup_1_spi_2_sleep>; pinctrl-1 = <&qup_1_spi_2_sleep>;
spi-max-frequency = <19200000>;
#address-cells = <1>; #address-cells = <1>;
#size-cells = <0>; #size-cells = <0>;
}; };
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment