Commit a90193b9 authored by Jerome Brunet's avatar Jerome Brunet Committed by Kevin Hilman

ARM64: dts: meson-axg: add s400 speaker amplifier

Add the first of the two tas5707 power amplifier present on the
speaker daughter board.

According to the schematics of the S400 v3, only I2SB_DIN3 and
I2SC_DOUT2 will be available to the speaker board.

9R83, 9R84 and 9R18 are not connected so no audio signal will be
provided to the second amplifier. There is no point in enabling it
even if it is visible on the i2c bus.
Signed-off-by: default avatarJerome Brunet <jbrunet@baylibre.com>
Signed-off-by: default avatarKevin Hilman <khilman@baylibre.com>
parent e120289c
......@@ -134,6 +134,19 @@ &i2c1 {
status = "okay";
pinctrl-0 = <&i2c1_z_pins>;
pinctrl-names = "default";
speaker_amp1: audio-codec@1b {
compatible = "ti,tas5707";
reg = <0x1b>;
reset-gpios = <&gpio_ao GPIOAO_4 GPIO_ACTIVE_LOW>;
#sound-dai-cells = <0>;
AVDD-supply = <&vcc_3v3>;
DVDD-supply = <&vcc_3v3>;
PVDD_A-supply = <&main_12v>;
PVDD_B-supply = <&main_12v>;
PVDD_C-supply = <&main_12v>;
PVDD_D-supply = <&main_12v>;
};
};
&i2c_AO {
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment