Commit a9911937 authored by Martin Willi's avatar Martin Willi Committed by Kalle Valo

ath10k: schedule hardware restart if WMI command times out

When running in AP mode, ath10k sometimes suffers from TX credit
starvation. The issue is hard to reproduce and shows up once in a
few days, but has been repeatedly seen with QCA9882 and a large
range of firmwares, including 10.2.4.70.67.

Once the module is in this state, TX credits are never replenished,
which results in "SWBA overrun" errors, as no beacons can be sent.
Even worse, WMI commands run in a timeout while holding the conf
mutex for three seconds each, making any further operations slow
and the whole system unresponsive.

The firmware/driver never recovers from that state automatically,
and triggering TX flush or warm restarts won't work over WMI. So
issue a hardware restart if a WMI command times out due to missing
TX credits. This implies a connectivity outage of about 1.4s in AP
mode, but brings back the interface and the whole system to a usable
state. WMI command timeouts have not been seen in absent of this
specific issue, so taking such drastic actions seems legitimate.
Signed-off-by: default avatarMartin Willi <martin@strongswan.org>
Signed-off-by: default avatarKalle Valo <kvalo@codeaurora.org>
parent 58da3b42
......@@ -1869,6 +1869,12 @@ int ath10k_wmi_cmd_send(struct ath10k *ar, struct sk_buff *skb, u32 cmd_id)
if (ret)
dev_kfree_skb_any(skb);
if (ret == -EAGAIN) {
ath10k_warn(ar, "wmi command %d timeout, restarting hardware\n",
cmd_id);
queue_work(ar->workqueue, &ar->restart_work);
}
return ret;
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment