net: wireless: p54spi: Fix commenting style

Make the commenting style consistent with networking block comment
style as suggested by checkpatch.
Signed-off-by: Sachin Kamat <sachin.kamat@linaro.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

drivers/net/wireless/p54/p54spi.c

@@ -42,8 +42,7 @@
 
 MODULE_FIRMWARE("3826.arm");
 
-/*
- * gpios should be handled in board files and provided via platform data,
+/* gpios should be handled in board files and provided via platform data,
  * but because it's currently impossible for p54spi to have a header file
  * in include/linux, let's use module paramaters for now
  */
@@ -191,8 +190,7 @@ static int p54spi_request_eeprom(struct ieee80211_hw *dev)
 	const struct firmware *eeprom;
 	int ret;
 
-	/*
-	 * allow users to customize their eeprom.
+	/* allow users to customize their eeprom.
 	 */
 
 	ret = request_firmware(&eeprom, "3826.eeprom", &priv->spi->dev);
@@ -285,8 +283,7 @@ static void p54spi_power_on(struct p54s_priv *priv)
 	gpio_set_value(p54spi_gpio_power, 1);
 	enable_irq(gpio_to_irq(p54spi_gpio_irq));
 
-	/*
-	 * need to wait a while before device can be accessed, the length
+	/* need to wait a while before device can be accessed, the length
 	 * is just a guess
 	 */
 	msleep(10);
@@ -365,7 +362,8 @@ static int p54spi_rx(struct p54s_priv *priv)
 	/* Firmware may insert up to 4 padding bytes after the lmac header,
 	 * but it does not amend the size of SPI data transfer.
 	 * Such packets has correct data size in header, thus referencing
-	 * past the end of allocated skb. Reserve extra 4 bytes for this case */
+	 * past the end of allocated skb. Reserve extra 4 bytes for this case
+	 */
 	skb = dev_alloc_skb(len + 4);
 	if (!skb) {
 		p54spi_sleep(priv);
@@ -383,7 +381,8 @@ static int p54spi_rx(struct p54s_priv *priv)
 	}
 	p54spi_sleep(priv);
 	/* Put additional bytes to compensate for the possible
-	 * alignment-caused truncation */
+	 * alignment-caused truncation
+	 */
 	skb_put(skb, 4);
 
 	if (p54_rx(priv->hw, skb) == 0)