[PATCH] Remove blkmtd

Remove the blkmtd driver.

- An alternative exists (block2mtd) that hasn't had  bug report for > 1 year.

- Most embedded people tend to use ancient kernels with custom patches from
  mtd cvs and elsewhere, so the 1 year warning period neither helps nor hurts
  them too much.

- It's in the way of klibc.  The problems caused by pulling blkmtd support
  are fairly low, while the problems caused by delaying klibc can be fairly
  substantial.  At best, this would be a severe burden on hpa's time.
Signed-off-by: Joern Engel <joern@wohnheim.fh-wedel.de>
Acked-by: Thomas Gleixner <tglx@linutronix.de>
Cc: "H. Peter Anvin" <hpa@zytor.com>
Cc: David Woodhouse <dwmw2@infradead.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

drivers/mtd/devices/Kconfig

@@ -129,8 +129,8 @@ config MTDRAM_ABS_POS
 	  allocating space from Linux's available memory. Otherwise, leave
 	  this set to zero. Most people will want to leave this as zero.
 
-config MTD_BLKMTD
-	tristate "MTD emulation using block device"
+config MTD_BLOCK2MTD
+	tristate "MTD using block device"
 	depends on MTD
 	help
 	  This driver allows a block device to appear as an MTD. It would
@@ -141,15 +141,6 @@ config MTD_BLKMTD
 	  Testing MTD users (eg JFFS2) on large media and media that might
 	  be removed during a write (using the floppy drive).
 
-config MTD_BLOCK2MTD
-	tristate "MTD using block device (rewrite)"
-	depends on MTD && EXPERIMENTAL
-	help
-	  This driver is basically the same at MTD_BLKMTD above, but
-	  experienced some interface changes plus serious speedups.  In
-	  the long term, it should replace MTD_BLKMTD.  Right now, you
-	  shouldn't entrust important data to it yet.
-
 comment "Disk-On-Chip Device Drivers"
 
 config MTD_DOC2000

drivers/mtd/devices/Makefile

@@ -21,7 +21,6 @@ obj-$(CONFIG_MTD_PMC551)	+= pmc551.o
 obj-$(CONFIG_MTD_MS02NV)	+= ms02-nv.o
 obj-$(CONFIG_MTD_MTDRAM)	+= mtdram.o
 obj-$(CONFIG_MTD_LART)		+= lart.o
-obj-$(CONFIG_MTD_BLKMTD)	+= blkmtd.o
 obj-$(CONFIG_MTD_BLOCK2MTD)	+= block2mtd.o
 obj-$(CONFIG_MTD_DATAFLASH)	+= mtd_dataflash.o
 obj-$(CONFIG_MTD_M25P80)	+= m25p80.o