dts: sun8i-h3: split off RTS/CTS for UART1 in seperate pinmux

This was done to make UART1-3 on H3 consistent, and less complicated to
enable UART1-3 on the breakout header on the several H3 board (notably
Orange Pi's). This patch adds a bit of complexity for the existing Banana
Pi, which already had the RTS/CTS associated on UART1.

The RTS/CTS for UART2-3 could be defined in the same way, but since
there is no actual use case for them at the moment, they are left out.
Signed-off-by: Jorik Jonker <jorik@kippendief.biz>
Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com>

arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts

@@ -185,7 +185,7 @@ &uart0 {
 
 &uart1 {
 	pinctrl-names = "default";
-	pinctrl-0 = <&uart1_pins_a>;
+	pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>;
 	status = "okay";
 };
 

arch/arm/boot/dts/sun8i-h3.dtsi

@@ -367,8 +367,15 @@ uart0_pins_a: uart0@0 {
 				allwinner,pull = <SUN4I_PINCTRL_NO_PULL>;
 			};
 
-			uart1_pins_a: uart1@0 {
-				allwinner,pins = "PG6", "PG7", "PG8", "PG9";
+			uart1_pins: uart1 {
+				allwinner,pins = "PG6", "PG7";
+				allwinner,function = "uart1";
+				allwinner,drive = <SUN4I_PINCTRL_10_MA>;
+				allwinner,pull = <SUN4I_PINCTRL_NO_PULL>;
+			};
+
+			uart1_rts_cts_pins: uart1_rts_cts {
+				allwinner,pins = "PG8", "PG9";
 				allwinner,function = "uart1";
 				allwinner,drive = <SUN4I_PINCTRL_10_MA>;
 				allwinner,pull = <SUN4I_PINCTRL_NO_PULL>;