Commit b4bd07e3 authored by Inaky Perez-Gonzalez's avatar Inaky Perez-Gonzalez

wimax/i2400m: don't reset device on i2400m_dev_shutdown()

i2400m_dev_shutdown() tried to reset the device to put it in a known
state before shutting down.

But that turned out to be pointless. We reach this case in two paths:

 1 - when the device resets, to clean up state
 2 - when the driver is unloaded, for the same

however, in both cases it is pointless; in (1) the device is already
reset, why do it again? in (2) we can't -- the USB stack, for example,
doesn't allow communicating with the device when the driver is being
unbound and if the device is disconnected, the device is gone already.

So just remove it. Leave the function as a placeholder for future
cleanups that will be done from data allocated by the driver during
device operation.
Signed-off-by: default avatarInaky Perez-Gonzalez <inaky@linux.intel.com>
parent 2971a5ba
......@@ -1396,16 +1396,16 @@ int i2400m_dev_initialize(struct i2400m *i2400m)
*
* @i2400m: device descriptor
*
* Gracefully stops the device, moving it to the lowest power
* consumption state possible.
* Release resources acquired during the running of the device; in
* theory, should also tell the device to go to sleep, switch off the
* radio, all that, but at this point, in most cases (driver
* disconnection, reset handling) we can't even talk to the device.
*/
void i2400m_dev_shutdown(struct i2400m *i2400m)
{
int result = -ENODEV;
struct device *dev = i2400m_dev(i2400m);
d_fnstart(3, dev, "(i2400m %p)\n", i2400m);
result = i2400m->bus_reset(i2400m, I2400M_RT_WARM);
d_fnend(3, dev, "(i2400m %p) = void [%d]\n", i2400m, result);
d_fnend(3, dev, "(i2400m %p) = void\n", i2400m);
return;
}
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment