ata: add missing ATA_* defines

Add missing ATA_* defines to <linux/ata.h>.  Also add
ATAPI_{LFS,EOM,ILI,IO,CODE} defines while at it.

Cc: Jeff Garzik <jeff@garzik.org>
Signed-off-by: default avatarBartlomiej Zolnierkiewicz <bzolnier@gmail.com>
parent 476d9894
...@@ -153,13 +153,26 @@ enum { ...@@ -153,13 +153,26 @@ enum {
ATA_BUSY = (1 << 7), /* BSY status bit */ ATA_BUSY = (1 << 7), /* BSY status bit */
ATA_DRDY = (1 << 6), /* device ready */ ATA_DRDY = (1 << 6), /* device ready */
ATA_DF = (1 << 5), /* device fault */ ATA_DF = (1 << 5), /* device fault */
ATA_DSC = (1 << 4), /* drive seek complete */
ATA_DRQ = (1 << 3), /* data request i/o */ ATA_DRQ = (1 << 3), /* data request i/o */
ATA_CORR = (1 << 2), /* corrected data error */
ATA_IDX = (1 << 1), /* index */
ATA_ERR = (1 << 0), /* have an error */ ATA_ERR = (1 << 0), /* have an error */
ATA_SRST = (1 << 2), /* software reset */ ATA_SRST = (1 << 2), /* software reset */
ATA_ICRC = (1 << 7), /* interface CRC error */ ATA_ICRC = (1 << 7), /* interface CRC error */
ATA_BBK = ATA_ICRC, /* pre-EIDE: block marked bad */
ATA_UNC = (1 << 6), /* uncorrectable media error */ ATA_UNC = (1 << 6), /* uncorrectable media error */
ATA_MC = (1 << 5), /* media changed */
ATA_IDNF = (1 << 4), /* ID not found */ ATA_IDNF = (1 << 4), /* ID not found */
ATA_MCR = (1 << 3), /* media change requested */
ATA_ABORTED = (1 << 2), /* command aborted */ ATA_ABORTED = (1 << 2), /* command aborted */
ATA_TRK0NF = (1 << 1), /* track 0 not found */
ATA_AMNF = (1 << 0), /* address mark not found */
ATAPI_LFS = 0xF0, /* last failed sense */
ATAPI_EOM = ATA_TRK0NF, /* end of media */
ATAPI_ILI = ATA_AMNF, /* illegal length indication */
ATAPI_IO = (1 << 1),
ATAPI_COD = (1 << 0),
/* ATA command block registers */ /* ATA command block registers */
ATA_REG_DATA = 0x00, ATA_REG_DATA = 0x00,
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment