i40e: Check if transceiver implements DDM before access

Similar to the ixgbe issue fixed in:
655c9141 ("ixgbe: Check DDM existence in transceiver before access)

i40e has the same issue when reading eeprom from SFP's module that comply
with SFF-8472 but not implement the Digital Diagnostic Monitoring (DDM)
interface described in it. The existence of such area is specified by bit
6 of byte 92, set to 1 if implemented.

Without this patch, due to not checking this bit i40e fails to read SFP
module's eeprom with the follow message:

ethtool -m enP51p1s0f0
Cannot get Module EEPROM data: Input/output error

Because it fails to read the additional 256 bytes in which it was assumed
to exist the DDM data.
Signed-off-by: "Mauro S. M. Rodrigues" <maurosr@linux.vnet.ibm.com>
Tested-by: Andrew Bowers <andrewx.bowers@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/i40e/i40e_ethtool.c

@@ -5137,6 +5137,12 @@ static int i40e_get_module_info(struct net_device *netdev,
 			/* Module is not SFF-8472 compliant */
 			modinfo->type = ETH_MODULE_SFF_8079;
 			modinfo->eeprom_len = ETH_MODULE_SFF_8079_LEN;
+		} else if (!(sff8472_swap & I40E_MODULE_SFF_DDM_IMPLEMENTED)) {
+			/* Module is SFF-8472 compliant but doesn't implement
+			 * Digital Diagnostic Monitoring (DDM).
+			 */
+			modinfo->type = ETH_MODULE_SFF_8079;
+			modinfo->eeprom_len = ETH_MODULE_SFF_8079_LEN;
 		} else {
 			modinfo->type = ETH_MODULE_SFF_8472;
 			modinfo->eeprom_len = ETH_MODULE_SFF_8472_LEN;

drivers/net/ethernet/intel/i40e/i40e_type.h

@@ -443,6 +443,7 @@ struct i40e_nvm_access {
 #define I40E_MODULE_SFF_8472_COMP	0x5E
 #define I40E_MODULE_SFF_8472_SWAP	0x5C
 #define I40E_MODULE_SFF_ADDR_MODE	0x04
+#define I40E_MODULE_SFF_DDM_IMPLEMENTED 0x40
 #define I40E_MODULE_TYPE_QSFP_PLUS	0x0D
 #define I40E_MODULE_TYPE_QSFP28		0x11
 #define I40E_MODULE_QSFP_MAX_LEN	640