Commit bd8fab39 authored by Denis Plotnikov's avatar Denis Plotnikov Committed by Radim Krčmář

KVM: x86: fix maintaining of kvm_clock stability on guest CPU hotplug

VCPU TSC synchronization is perfromed in kvm_write_tsc() when the TSC
value being set is within 1 second from the expected, as obtained by
extrapolating of the TSC in already synchronized VCPUs.

This is naturally achieved on all VCPUs at VM start and resume;
however on VCPU hotplug it is not: the newly added VCPU is created
with TSC == 0 while others are well ahead.

To compensate for that, consider host-initiated kvm_write_tsc() with
TSC == 0 a special case requiring synchronization regardless of the
current TSC on other VCPUs.
Signed-off-by: default avatarDenis Plotnikov <dplotnikov@virtuozzo.com>
Reviewed-by: default avatarRoman Kagan <rkagan@virtuozzo.com>
Signed-off-by: default avatarRadim Krčmář <rkrcmar@redhat.com>
parent c5e8ec8e
......@@ -1454,16 +1454,25 @@ void kvm_write_tsc(struct kvm_vcpu *vcpu, struct msr_data *msr)
elapsed = ns - kvm->arch.last_tsc_nsec;
if (vcpu->arch.virtual_tsc_khz) {
u64 tsc_exp = kvm->arch.last_tsc_write +
nsec_to_cycles(vcpu, elapsed);
u64 tsc_hz = vcpu->arch.virtual_tsc_khz * 1000LL;
/*
* Special case: TSC write with a small delta (1 second)
* of virtual cycle time against real time is
* interpreted as an attempt to synchronize the CPU.
*/
synchronizing = data < tsc_exp + tsc_hz &&
data + tsc_hz > tsc_exp;
if (data == 0 && msr->host_initiated) {
/*
* detection of vcpu initialization -- need to sync
* with other vCPUs. This particularly helps to keep
* kvm_clock stable after CPU hotplug
*/
synchronizing = true;
} else {
u64 tsc_exp = kvm->arch.last_tsc_write +
nsec_to_cycles(vcpu, elapsed);
u64 tsc_hz = vcpu->arch.virtual_tsc_khz * 1000LL;
/*
* Special case: TSC write with a small delta (1 second)
* of virtual cycle time against real time is
* interpreted as an attempt to synchronize the CPU.
*/
synchronizing = data < tsc_exp + tsc_hz &&
data + tsc_hz > tsc_exp;
}
}
/*
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment