net: marvell: mvpp2: fix lack of link interrupts

Sven Auhagen reports that if he changes a SFP+ module for a SFP module
on the Macchiatobin Single Shot, the link does not come back up.  For
Sven, it is as easy as:

- Insert a SFP+ module connected, and use ping6 to verify link is up.
- Remove SFP+ module
- Insert SFP 1000base-X module use ping6 to verify link is up: Link
  up event did not trigger and the link is down

but that doesn't show the problem for me.  Locally, this has been
reproduced by:

- Boot with no modules.
- Insert SFP+ module, confirm link is up.
- Replace module with 25000base-X module.  Confirm link is up.
- Set remote end down, link is reported as dropped at both ends.
- Set remote end up, link is reported up at remote end, but not local
  end due to lack of link interrupt.

Fix this by setting up both GMAC and XLG interrupts for port 0, but
only unmasking the appropriate interrupt according to the current mode
set in the mac_config() method.  However, only do the mask/unmask
dance when we are really changing the link mode to avoid missing any
link interrupts.
Tested-by: Sven Auhagen <sven.auhagen@voleatech.de>
Signed-off-by: Russell King <rmk+kernel@armlinux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c

@@ -1133,7 +1133,8 @@ static void mvpp22_gop_setup_irq(struct mvpp2_port *port)
 {
 	u32 val;
 
-	if (phy_interface_mode_is_rgmii(port->phy_interface) ||
+	if (port->phylink ||
+	    phy_interface_mode_is_rgmii(port->phy_interface) ||
 	    phy_interface_mode_is_8023z(port->phy_interface) ||
 	    port->phy_interface == PHY_INTERFACE_MODE_SGMII) {
 		val = readl(port->base + MVPP22_GMAC_INT_MASK);
@@ -4620,6 +4621,7 @@ static void mvpp2_mac_config(struct net_device *dev, unsigned int mode,
 			     const struct phylink_link_state *state)
 {
 	struct mvpp2_port *port = netdev_priv(dev);
+	bool change_interface = port->phy_interface != state->interface;
 
 	/* Check for invalid configuration */
 	if (state->interface == PHY_INTERFACE_MODE_10GKR && port->gop_id != 0) {
@@ -4629,14 +4631,16 @@ static void mvpp2_mac_config(struct net_device *dev, unsigned int mode,
 
 	/* Make sure the port is disabled when reconfiguring the mode */
 	mvpp2_port_disable(port);
+	if (change_interface) {
+		mvpp22_gop_mask_irq(port);
 
-	if (port->priv->hw_version == MVPP22 &&
-	    port->phy_interface != state->interface) {
-		port->phy_interface = state->interface;
+		if (port->priv->hw_version == MVPP22) {
+			port->phy_interface = state->interface;
 
-		/* Reconfigure the serdes lanes */
-		phy_power_off(port->comphy);
-		mvpp22_mode_reconfigure(port);
+			/* Reconfigure the serdes lanes */
+			phy_power_off(port->comphy);
+			mvpp22_mode_reconfigure(port);
+		}
 	}
 
 	/* mac (re)configuration */
@@ -4650,6 +4654,9 @@ static void mvpp2_mac_config(struct net_device *dev, unsigned int mode,
 	if (port->priv->hw_version == MVPP21 && port->flags & MVPP2_F_LOOPBACK)
 		mvpp2_port_loopback_set(port, state);
 
+	if (change_interface)
+		mvpp22_gop_unmask_irq(port);
+
 	mvpp2_port_enable(port);
 }