net: phy: remove calls to genphy_config_init

Supported PHY features are either auto-detected or explicitly set.
In both cases calling genphy_config_init isn't needed. All that
genphy_config_init does is removing features that are set as
supported but can't be auto-detected. Basically it duplicates the
code in genphy_read_abilities. Therefore remove such calls from
all PHY drivers.

v2:
- remove call also from new adin PHY driver
v3:
- pass NULL as config_init function pointer for dp83848
Signed-off-by: Heiner Kallweit <hkallweit1@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/phy/adin.c

@@ -356,10 +356,6 @@ static int adin_config_init(struct phy_device *phydev)
 
 	phydev->mdix_ctrl = ETH_TP_MDI_AUTO;
 
-	rc = genphy_config_init(phydev);
-	if (rc < 0)
-		return rc;
-
 	rc = adin_config_rgmii_mode(phydev);
 	if (rc < 0)
 		return rc;

drivers/net/phy/at803x.c

@@ -249,10 +249,6 @@ static int at803x_config_init(struct phy_device *phydev)
 {
 	int ret;
 
-	ret = genphy_config_init(phydev);
-	if (ret < 0)
-		return ret;
-
 	/* The RX and TX delay default is:
 	 *   after HW reset: RX delay enabled and TX delay disabled
 	 *   after SW reset: RX delay enabled, while TX delay retains the

drivers/net/phy/dp83822.c

@@ -254,13 +254,8 @@ static int dp83822_config_intr(struct phy_device *phydev)
 
 static int dp83822_config_init(struct phy_device *phydev)
 {
-	int err;
 	int value;
 
-	err = genphy_config_init(phydev);
-	if (err < 0)
-		return err;
-
 	value = DP83822_WOL_MAGIC_EN | DP83822_WOL_SECURE_ON | DP83822_WOL_EN;
 
 	return phy_write_mmd(phydev, DP83822_DEVADDR, MII_DP83822_WOL_CFG,

drivers/net/phy/dp83848.c

@@ -68,13 +68,8 @@ static int dp83848_config_intr(struct phy_device *phydev)
 
 static int dp83848_config_init(struct phy_device *phydev)
 {
-	int err;
 	int val;
 
-	err = genphy_config_init(phydev);
-	if (err < 0)
-		return err;
-
 	/* DP83620 always reports Auto Negotiation Ability on BMSR. Instead,
 	 * we check initial value of BMCR Auto negotiation enable bit
 	 */
@@ -113,13 +108,13 @@ MODULE_DEVICE_TABLE(mdio, dp83848_tbl);
 
 static struct phy_driver dp83848_driver[] = {
 	DP83848_PHY_DRIVER(TI_DP83848C_PHY_ID, "TI DP83848C 10/100 Mbps PHY",
-			   genphy_config_init),
+			   NULL),
 	DP83848_PHY_DRIVER(NS_DP83848C_PHY_ID, "NS DP83848C 10/100 Mbps PHY",
-			   genphy_config_init),
+			   NULL),
 	DP83848_PHY_DRIVER(TI_DP83620_PHY_ID, "TI DP83620 10/100 Mbps PHY",
 			   dp83848_config_init),
 	DP83848_PHY_DRIVER(TLK10X_PHY_ID, "TI TLK10X 10/100 Mbps PHY",
-			   genphy_config_init),
+			   NULL),
 };
 module_phy_driver(dp83848_driver);
 

drivers/net/phy/dp83tc811.c

@@ -277,10 +277,6 @@ static int dp83811_config_init(struct phy_device *phydev)
 {
 	int value, err;
 
-	err = genphy_config_init(phydev);
-	if (err < 0)
-		return err;
-
 	value = phy_read(phydev, MII_DP83811_SGMII_CTRL);
 	if (phydev->interface == PHY_INTERFACE_MODE_SGMII) {
 		err = phy_write(phydev, MII_DP83811_SGMII_CTRL,

drivers/net/phy/meson-gxl.c

@@ -136,7 +136,7 @@ static int meson_gxl_config_init(struct phy_device *phydev)
 	if (ret)
 		return ret;
 
-	return genphy_config_init(phydev);
+	return 0;
 }
 
 /* This function is provided to cope with the possible failures of this phy

drivers/net/phy/microchip.c

@@ -305,7 +305,6 @@ static int lan88xx_config_init(struct phy_device *phydev)
 {
 	int val;
 
-	genphy_config_init(phydev);
 	/*Zerodetect delay enable */
 	val = phy_read_mmd(phydev, MDIO_MMD_PCS,
 			   PHY_ARDENNES_MMD_DEV_3_PHY_CFG);

drivers/net/phy/microchip_t1.c

@@ -48,7 +48,6 @@ static struct phy_driver microchip_t1_phy_driver[] = {
 
 		.features       = PHY_BASIC_T1_FEATURES,
 
-		.config_init    = genphy_config_init,
 		.config_aneg    = genphy_config_aneg,
 
 		.ack_interrupt  = lan87xx_phy_ack_interrupt,

drivers/net/phy/mscc.c

@@ -1725,7 +1725,7 @@ static int vsc8584_config_init(struct phy_device *phydev)
 			return ret;
 	}
 
-	return genphy_config_init(phydev);
+	return 0;
 
 err:
 	mutex_unlock(&phydev->mdio.bus->mdio_lock);
@@ -1767,7 +1767,7 @@ static int vsc85xx_config_init(struct phy_device *phydev)
 			return rc;
 	}
 
-	return genphy_config_init(phydev);
+	return 0;
 }
 
 static int vsc8584_did_interrupt(struct phy_device *phydev)

drivers/net/phy/vitesse.c

@@ -197,7 +197,7 @@ static int vsc738x_config_init(struct phy_device *phydev)
 
 	vsc73xx_config_init(phydev);
 
-	return genphy_config_init(phydev);
+	return 0;
 }
 
 static int vsc739x_config_init(struct phy_device *phydev)
@@ -229,7 +229,7 @@ static int vsc739x_config_init(struct phy_device *phydev)
 
 	vsc73xx_config_init(phydev);
 
-	return genphy_config_init(phydev);
+	return 0;
 }
 
 static int vsc73xx_config_aneg(struct phy_device *phydev)
@@ -267,7 +267,7 @@ static int vsc8601_config_init(struct phy_device *phydev)
 	if (ret < 0)
 		return ret;
 
-	return genphy_config_init(phydev);
+	return 0;
 }
 
 static int vsc824x_ack_interrupt(struct phy_device *phydev)