[netdrvr] ne: Use CONFIG_MACH_TX49XX

After some cleanups in arch/mips area, now MACH_TX49XX is selected for
both TOSHIBA_RBTX4927 and TOSHIBA_RBTX4938.  Fold these two conditions
to one.
Signed-off-by: Atsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

drivers/net/Kconfig

@@ -1172,7 +1172,7 @@ config ETH16I
 
 config NE2000
 	tristate "NE2000/NE1000 support"
-	depends on NET_ISA || (Q40 && m) || M32R || TOSHIBA_RBTX4927 || TOSHIBA_RBTX4938
+	depends on NET_ISA || (Q40 && m) || M32R || MACH_TX49XX
 	select CRC32
 	---help---
 	  If you have a network (Ethernet) card of this type, say Y and read

drivers/net/ne.c

@@ -118,7 +118,7 @@ bad_clone_list[] __initdata = {
     {"E-LAN100", "E-LAN200", {0x00, 0x00, 0x5d}}, /* Broken ne1000 clones */
     {"PCM-4823", "PCM-4823", {0x00, 0xc0, 0x6c}}, /* Broken Advantech MoBo */
     {"REALTEK", "RTL8019", {0x00, 0x00, 0xe8}}, /* no-name with Realtek chip */
-#if defined(CONFIG_TOSHIBA_RBTX4927) || defined(CONFIG_TOSHIBA_RBTX4938)
+#ifdef CONFIG_MACH_TX49XX
     {"RBHMA4X00-RTL8019", "RBHMA4X00/RTL8019", {0x00, 0x60, 0x0a}},  /* Toshiba built-in */
 #endif
     {"LCS-8834", "LCS-8836", {0x04, 0x04, 0x37}}, /* ShinyNet (SET) */
@@ -142,7 +142,7 @@ bad_clone_list[] __initdata = {
 #if defined(CONFIG_PLAT_MAPPI)
 #  define DCR_VAL 0x4b
 #elif defined(CONFIG_PLAT_OAKS32R)  || \
-   defined(CONFIG_TOSHIBA_RBTX4927) || defined(CONFIG_TOSHIBA_RBTX4938)
+   defined(CONFIG_MACH_TX49XX)
 #  define DCR_VAL 0x48		/* 8-bit mode */
 #else
 #  define DCR_VAL 0x49