Commit c91e3234 authored by Fabrice Gasnier's avatar Fabrice Gasnier Committed by Thierry Reding

pwm: stm32-lp: Add check in case requested period cannot be achieved

LPTimer can use a 32KHz clock for counting. It depends on clock tree
configuration. In such a case, PWM output frequency range is limited.
Although unlikely, nothing prevents user from requesting a PWM frequency
above counting clock (32KHz for instance):
- This causes (prd - 1) = 0xffff to be written in ARR register later in
the apply() routine.
This results in badly configured PWM period (and also duty_cycle).
Add a check to report an error is such a case.
Signed-off-by: default avatarFabrice Gasnier <fabrice.gasnier@st.com>
Reviewed-by: default avatarUwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: default avatarThierry Reding <thierry.reding@gmail.com>
parent 71523d18
......@@ -59,6 +59,12 @@ static int stm32_pwm_lp_apply(struct pwm_chip *chip, struct pwm_device *pwm,
/* Calculate the period and prescaler value */
div = (unsigned long long)clk_get_rate(priv->clk) * state->period;
do_div(div, NSEC_PER_SEC);
if (!div) {
/* Clock is too slow to achieve requested period. */
dev_dbg(priv->chip.dev, "Can't reach %u ns\n", state->period);
return -EINVAL;
}
prd = div;
while (div > STM32_LPTIM_MAX_ARR) {
presc++;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment