Commit ca460f86 authored by David Henningsson's avatar David Henningsson Committed by Takashi Iwai

ALSA: hda - Fix CORB reset to follow specification

According to the HDA spec, we must write 1 to bit 15 on a CORBRP
reset, read back 1, then write 0, then read back 0. This must be
done while the DMA is not running.

We accidentaly ended up writing back the 0 by using a writel
instead of a writew to CORBWP.

This caused occasional controller failure on Bay Trail hardware.

[replaced error messages with dev_err() by tiwai]
Signed-off-by: default avatarDavid Henningsson <david.henningsson@canonical.com>
Signed-off-by: default avatarTakashi Iwai <tiwai@suse.de>
parent d604b399
......@@ -769,6 +769,8 @@ static int azx_alloc_cmd_io(struct azx *chip)
static void azx_init_cmd_io(struct azx *chip)
{
int timeout;
spin_lock_irq(&chip->reg_lock);
/* CORB set up */
chip->corb.addr = chip->rb.addr;
......@@ -780,8 +782,28 @@ static void azx_init_cmd_io(struct azx *chip)
azx_writeb(chip, CORBSIZE, 0x02);
/* set the corb write pointer to 0 */
azx_writew(chip, CORBWP, 0);
/* reset the corb hw read pointer */
azx_writew(chip, CORBRP, ICH6_CORBRP_RST);
for (timeout = 1000; timeout > 0; timeout--) {
if ((azx_readw(chip, CORBRP) & ICH6_CORBRP_RST) == ICH6_CORBRP_RST)
break;
udelay(1);
}
if (timeout <= 0)
dev_err(chip->card->dev, "CORB reset timeout#1, CORBRP = %d\n",
azx_readw(chip, CORBRP));
azx_writew(chip, CORBRP, 0);
for (timeout = 1000; timeout > 0; timeout--) {
if (azx_readw(chip, CORBRP) == 0)
break;
udelay(1);
}
if (timeout <= 0)
dev_err(chip->card->dev, "CORB reset timeout#2, CORBRP = %d\n",
azx_readw(chip, CORBRP));
/* enable corb dma */
azx_writeb(chip, CORBCTL, ICH6_CORBCTL_RUN);
......@@ -856,7 +878,7 @@ static int azx_corb_send_cmd(struct hda_bus *bus, u32 val)
chip->rirb.cmds[addr]++;
chip->corb.buf[wp] = cpu_to_le32(val);
azx_writel(chip, CORBWP, wp);
azx_writew(chip, CORBWP, wp);
spin_unlock_irq(&chip->reg_lock);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment