Commit cd6c524e authored by Dmitry TARNYAGIN's avatar Dmitry TARNYAGIN Committed by John W. Linville

mac80211: Do not request FIF_BCN_PRBRESP_PROMISC for HW scan.

ieee80211_configure_filter code used local->scanning as a boolean
value when it was a bit mask. Bits SCAN_COMPLETED, SCAN_ABORTED
should not set FIF_BCN_PRBRESP_PROMISC filter.

SCAN_HW_SCANNING should not set FIF_BCN_PRBRESP_PROMISC either,
as there is no explicit filter configuration request from
scan code. If a driver requires FIF_BCN_PRBRESP_PROMISC mode
during HW scanning, it's up to the driver to temporary enable it.

Similar mistake was fixed also in ieee80211_hw_config (power
configuration code).
Verified-by: default avatarVitaly Wool <vitaly.wool@sonyericsson.com>
Signed-off-by: default avatarDmitry Tarnyagin <dmitry.tarnyagin@stericsson.com>
Signed-off-by: default avatarJohn W. Linville <linville@tuxdriver.com>
parent 6539306b
......@@ -47,7 +47,7 @@ void ieee80211_configure_filter(struct ieee80211_local *local)
if (atomic_read(&local->iff_allmultis))
new_flags |= FIF_ALLMULTI;
if (local->monitors || local->scanning)
if (local->monitors || test_bit(SCAN_SW_SCANNING, &local->scanning))
new_flags |= FIF_BCN_PRBRESP_PROMISC;
if (local->fif_probe_req || local->probe_req_reg)
......@@ -150,8 +150,8 @@ int ieee80211_hw_config(struct ieee80211_local *local, u32 changed)
changed |= IEEE80211_CONF_CHANGE_SMPS;
}
if ((local->scanning & SCAN_SW_SCANNING) ||
(local->scanning & SCAN_HW_SCANNING))
if (test_bit(SCAN_SW_SCANNING, &local->scanning) ||
test_bit(SCAN_HW_SCANNING, &local->scanning))
power = chan->max_power;
else
power = local->power_constr_level ?
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment