dt-bindings: regulator: remove interrupt-parent description on stpmic1

The interrupt parent description is not needed as the parent is a parent
node with 'interrupt-controller' property.
Signed-off-by: pascal paillet <p.paillet@st.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Documentation/devicetree/bindings/regulator/st,stpmic1-regulator.txt

@@ -29,7 +29,6 @@ Optional properties:
     if set, all regulators are switched off in case of over-current detection
     on this regulator,
     if not set, the driver only sends an over-current event.
-- interrupt-parent: phandle to the parent interrupt controller
 - interrupts: index of current limit detection interrupt
 - <regulator>-supply: phandle to the parent supply/regulator node
 	each regulator supply can be described except vref_ddr.
@@ -43,7 +42,6 @@ regulators {
 	vdd_core: buck1 {
 		regulator-name = "vdd_core";
 		interrupts = <IT_CURLIM_BUCK1 0>;
-		interrupt-parent = <&pmic>;
 		st,mask-reset;
 		regulator-pull-down;
 		regulator-min-microvolt = <700000>;
@@ -53,7 +51,6 @@ regulators {
 	v3v3: buck4 {
 		regulator-name = "v3v3";
 		interrupts = <IT_CURLIM_BUCK4 0>;
-		interrupt-parent = <&mypmic>;
 
 		regulator-min-microvolt = <3300000>;
 		regulator-max-microvolt = <3300000>;