Commit d6a2c5c7 authored by Sara Sharon's avatar Sara Sharon Committed by Luca Coelho

iwlwifi: pcie: fix ucode load flow for a000 devices

Turns out we should access TFH relative addresses.
Also, the FH_UCODE_LOAD_STATUS was replaced by
UREG_UCODE_LOAD_STATUS.
Signed-off-by: default avatarSara Sharon <sara.sharon@intel.com>
Signed-off-by: default avatarLuca Coelho <luciano.coelho@intel.com>
parent ae79785f
......@@ -77,7 +77,6 @@
*/
#define FH_MEM_LOWER_BOUND (0x1000)
#define FH_MEM_UPPER_BOUND (0x2000)
#define TFH_MEM_LOWER_BOUND (0xA06000)
/**
* Keep-Warm (KW) buffer base address.
......@@ -120,7 +119,7 @@
#define FH_MEM_CBBC_20_31_LOWER_BOUND (FH_MEM_LOWER_BOUND + 0xB20)
#define FH_MEM_CBBC_20_31_UPPER_BOUND (FH_MEM_LOWER_BOUND + 0xB80)
/* a000 TFD table address, 64 bit */
#define TFH_TFDQ_CBB_TABLE (TFH_MEM_LOWER_BOUND + 0x1C00)
#define TFH_TFDQ_CBB_TABLE (0x1C00)
/* Find TFD CB base pointer for given queue */
static inline unsigned int FH_MEM_CBBC_QUEUE(struct iwl_trans *trans,
......@@ -156,7 +155,7 @@ static inline unsigned int FH_MEM_CBBC_QUEUE(struct iwl_trans *trans,
* In case of DRAM read address which is not aligned to 128B, the TFH will
* enable transfer size which doesn't cross 64B DRAM address boundary.
*/
#define TFH_TRANSFER_MODE (TFH_MEM_LOWER_BOUND + 0x1F40)
#define TFH_TRANSFER_MODE (0x1F40)
#define TFH_TRANSFER_MAX_PENDING_REQ 0xc
#define TFH_CHUNK_SIZE_128 BIT(8)
#define TFH_CHUNK_SPLIT_MODE BIT(10)
......@@ -167,7 +166,7 @@ static inline unsigned int FH_MEM_CBBC_QUEUE(struct iwl_trans *trans,
* the start of the TFD first TB.
* In case of a DRAM Tx CMD update the TFH will update PN and Key ID
*/
#define TFH_TXCMD_UPDATE_CFG (TFH_MEM_LOWER_BOUND + 0x1F48)
#define TFH_TXCMD_UPDATE_CFG (0x1F48)
/*
* Controls TX DMA operation
*
......@@ -181,22 +180,22 @@ static inline unsigned int FH_MEM_CBBC_QUEUE(struct iwl_trans *trans,
* set to 1 - interrupt is sent to the driver
* Bit 0: Indicates the snoop configuration
*/
#define TFH_SRV_DMA_CHNL0_CTRL (TFH_MEM_LOWER_BOUND + 0x1F60)
#define TFH_SRV_DMA_CHNL0_CTRL (0x1F60)
#define TFH_SRV_DMA_SNOOP BIT(0)
#define TFH_SRV_DMA_TO_DRIVER BIT(24)
#define TFH_SRV_DMA_START BIT(31)
/* Defines the DMA SRAM write start address to transfer a data block */
#define TFH_SRV_DMA_CHNL0_SRAM_ADDR (TFH_MEM_LOWER_BOUND + 0x1F64)
#define TFH_SRV_DMA_CHNL0_SRAM_ADDR (0x1F64)
/* Defines the 64bits DRAM start address to read the DMA data block from */
#define TFH_SRV_DMA_CHNL0_DRAM_ADDR (TFH_MEM_LOWER_BOUND + 0x1F68)
#define TFH_SRV_DMA_CHNL0_DRAM_ADDR (0x1F68)
/*
* Defines the number of bytes to transfer from DRAM to SRAM.
* Note that this register may be configured with non-dword aligned size.
*/
#define TFH_SRV_DMA_CHNL0_BC (TFH_MEM_LOWER_BOUND + 0x1F70)
#define TFH_SRV_DMA_CHNL0_BC (0x1F70)
/**
* Rx SRAM Control and Status Registers (RSCSR)
......
......@@ -303,6 +303,14 @@
#define FH_UCODE_LOAD_STATUS (0x1AF0)
#define CSR_UCODE_LOAD_STATUS_ADDR (0x1E70)
/*
* Replacing FH_UCODE_LOAD_STATUS
* This register is writen by driver and is read by uCode during boot flow.
* Note this address is cleared after MAC reset.
*/
#define UREG_UCODE_LOAD_STATUS (0xa05c40)
enum secure_load_status_reg {
LMPM_CPU_UCODE_LOADING_STARTED = 0x00000001,
LMPM_CPU_HDRS_LOADING_COMPLETED = 0x00000003,
......
......@@ -827,10 +827,16 @@ static int iwl_pcie_load_cpu_sections_8000(struct iwl_trans *trans,
if (ret)
return ret;
/* Notify the ucode of the loaded section number and status */
val = iwl_read_direct32(trans, FH_UCODE_LOAD_STATUS);
val = val | (sec_num << shift_param);
iwl_write_direct32(trans, FH_UCODE_LOAD_STATUS, val);
/* Notify ucode of loaded section number and status */
if (trans->cfg->use_tfh) {
val = iwl_read_prph(trans, UREG_UCODE_LOAD_STATUS);
val = val | (sec_num << shift_param);
iwl_write_prph(trans, UREG_UCODE_LOAD_STATUS, val);
} else {
val = iwl_read_direct32(trans, FH_UCODE_LOAD_STATUS);
val = val | (sec_num << shift_param);
iwl_write_direct32(trans, FH_UCODE_LOAD_STATUS, val);
}
sec_num = (sec_num << 1) | 0x1;
}
......@@ -838,10 +844,21 @@ static int iwl_pcie_load_cpu_sections_8000(struct iwl_trans *trans,
iwl_enable_interrupts(trans);
if (cpu == 1)
iwl_write_direct32(trans, FH_UCODE_LOAD_STATUS, 0xFFFF);
else
iwl_write_direct32(trans, FH_UCODE_LOAD_STATUS, 0xFFFFFFFF);
if (trans->cfg->use_tfh) {
if (cpu == 1)
iwl_write_prph(trans, UREG_UCODE_LOAD_STATUS,
0xFFFF);
else
iwl_write_prph(trans, UREG_UCODE_LOAD_STATUS,
0xFFFFFFFF);
} else {
if (cpu == 1)
iwl_write_direct32(trans, FH_UCODE_LOAD_STATUS,
0xFFFF);
else
iwl_write_direct32(trans, FH_UCODE_LOAD_STATUS,
0xFFFFFFFF);
}
return 0;
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment