[media] siano: Remove bogus complain about MSG_SMS_DVBT_BDA_DATA

When the driver is tuned into chanel, and it is removed/reinserted,
the message stream data may be arriving during device probe:
	[ 5680.162004] smscore_set_device_mode: set device mode to 6
	[ 5680.162267] smscore_onresponse: message MSG_SMS_DVBT_BDA_DATA(693) not handled.
	[ 5680.162391] smscore_onresponse: message MSG_SMS_DVBT_BDA_DATA(693) not handled.
	[ 5680.162641] smscore_onresponse: message MSG_SMS_DVBT_BDA_DATA(693) not handled.
	[ 5680.162891] smscore_onresponse: message MSG_SMS_DVBT_BDA_DATA(693) not handled.
	[ 5680.163016] smscore_onresponse: message MSG_SMS_DVBT_BDA_DATA(693) not handled.
	[ 5680.163266] smscore_onresponse: message MSG_SMS_DVBT_BDA_DATA(693) not handled.
	[ 5680.163516] smscore_onresponse: message MSG_SMS_DVBT_BDA_DATA(693) not handled.
	[ 5680.163640] smscore_onresponse: message MSG_SMS_DVBT_BDA_DATA(693) not handled.
	[ 5680.163891] smscore_onresponse: message MSG_SMS_DVBT_BDA_DATA(693) not handled.
	[ 5680.164016] smscore_onresponse: message MSG_SMS_DVBT_BDA_DATA(693) not handled.
	[ 5680.164265] smscore_onresponse: message MSG_SMS_DVBT_BDA_DATA(693) not handled.
	[ 5680.164515] smscore_onresponse: message MSG_SMS_DVBT_BDA_DATA(693) not handled.
	[ 5680.164519] smscore_onresponse: Firmware id 6 prots 0x40 ver 8.1
	[ 5680.164766] smscore_onresponse: message MSG_SMS_DVBT_BDA_DATA(693) not handled.
	[ 5680.166018] smscore_onresponse: message MSG_SMS_DVBT_BDA_DATA(693) not handled.
	[ 5680.166438] DVB: registering new adapter (Siano Rio Digital Receiver)
Instead of complaining, just silently discard those messages, instead of
complaining.
A proper fix is to put the device on suspend/power down mode when the module
is removed.
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>

drivers/media/common/siano/smscoreapi.c

@@ -1605,6 +1605,15 @@ void smscore_onresponse(struct smscore_device_t *coredev,
 				- sizeof(struct SmsMsgHdr_ST));
 			break;
 
+		case MSG_SMS_DVBT_BDA_DATA:
+			/*
+			 * It can be received here, if the frontend is
+			 * tuned into a valid channel and the proper firmware
+			 * is loaded. That happens when the module got removed
+			 * and re-inserted, without powering the device off
+			 */
+			break;
+
 		default:
 			sms_debug("message %s(%d) not handled.",
 				  smscore_translate_msg(phdr->msgType),