Commit e6e074f1 authored by Andrew Vasquez's avatar Andrew Vasquez Committed by James Bottomley

[SCSI] qla2xxx: Correct issue where incorrect init-fw mailbox command was used...

[SCSI] qla2xxx: Correct issue where incorrect init-fw mailbox command was used on non-NPIV capable ISPs.

BIT_2 of the firmware attributes is only valid on FW-interface-2
type HBAs.  Code in commit
c48339de would cause the
incorrect initialize-firmware mailbox command to be issued for
non-NPIV capable ISPs.  Correct this by reverting to previously
used (and correct) pre-condition 'if' check.
Signed-off-by: default avatarAndrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: default avatarJames Bottomley <James.Bottomley@HansenPartnership.com>
parent da4541b6
...@@ -980,7 +980,7 @@ qla2x00_init_firmware(scsi_qla_host_t *ha, uint16_t size) ...@@ -980,7 +980,7 @@ qla2x00_init_firmware(scsi_qla_host_t *ha, uint16_t size)
DEBUG11(printk("qla2x00_init_firmware(%ld): entered.\n", DEBUG11(printk("qla2x00_init_firmware(%ld): entered.\n",
ha->host_no)); ha->host_no));
if (ha->fw_attributes & BIT_2) if (ha->flags.npiv_supported)
mcp->mb[0] = MBC_MID_INITIALIZE_FIRMWARE; mcp->mb[0] = MBC_MID_INITIALIZE_FIRMWARE;
else else
mcp->mb[0] = MBC_INITIALIZE_FIRMWARE; mcp->mb[0] = MBC_INITIALIZE_FIRMWARE;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment