Merge branch 'qed-general-fixes'

Yuval Mintz says:

====================
qed*: General fixes

This series contain several fixes for qed and qede.

 - #1 [and ~#5] relate to XDP cleanups
 - #2 and #5 correct VF behavior
 - #3 and #4 fix and add missing configurations needed for RoCE & storage
====================
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/qlogic/qed/qed_cxt.c

@@ -1460,6 +1460,7 @@ void qed_qm_init_pf(struct qed_hwfn *p_hwfn, struct qed_ptt *p_ptt)
 	params.is_first_pf = p_hwfn->first_on_engine;
 	params.num_pf_cids = iids.cids;
 	params.num_vf_cids = iids.vf_cids;
+	params.num_tids = iids.tids;
 	params.start_pq = qm_info->start_pq;
 	params.num_pf_pqs = qm_info->num_pqs - qm_info->num_vf_pqs;
 	params.num_vf_pqs = qm_info->num_vf_pqs;

drivers/net/ethernet/qlogic/qed/qed_dev.c

@@ -1370,7 +1370,7 @@ qed_hw_init_pf_doorbell_bar(struct qed_hwfn *p_hwfn, struct qed_ptt *p_ptt)
 						   NULL) +
 		       qed_cxt_get_proto_cid_count(p_hwfn, PROTOCOLID_ETH,
 						   NULL);
-	norm_regsize = roundup(QED_PF_DEMS_SIZE * non_pwm_conn, 4096);
+	norm_regsize = roundup(QED_PF_DEMS_SIZE * non_pwm_conn, PAGE_SIZE);
 	min_addr_reg1 = norm_regsize / 4096;
 	pwm_regsize = db_bar_size - norm_regsize;
 

drivers/net/ethernet/qlogic/qed/qed_main.c

@@ -1093,10 +1093,12 @@ static int qed_slowpath_stop(struct qed_dev *cdev)
 		qed_free_stream_mem(cdev);
 		if (IS_QED_ETH_IF(cdev))
 			qed_sriov_disable(cdev, true);
+	}
+
+	qed_nic_stop(cdev);
 
-		qed_nic_stop(cdev);
+	if (IS_PF(cdev))
 		qed_slowpath_irq_free(cdev);
-	}
 
 	qed_disable_msix(cdev);
 

drivers/net/ethernet/qlogic/qede/qede_filter.c

@@ -1028,11 +1028,6 @@ int qede_xdp(struct net_device *dev, struct netdev_xdp *xdp)
 {
 	struct qede_dev *edev = netdev_priv(dev);
 
-	if (IS_VF(edev)) {
-		DP_NOTICE(edev, "VFs don't support XDP\n");
-		return -EOPNOTSUPP;
-	}
-
 	switch (xdp->command) {
 	case XDP_SETUP_PROG:
 		return qede_xdp_set(edev, xdp->prog);

drivers/net/ethernet/qlogic/qede/qede_main.c

@@ -563,6 +563,23 @@ static const struct net_device_ops qede_netdev_ops = {
 #endif
 };
 
+static const struct net_device_ops qede_netdev_vf_ops = {
+	.ndo_open = qede_open,
+	.ndo_stop = qede_close,
+	.ndo_start_xmit = qede_start_xmit,
+	.ndo_set_rx_mode = qede_set_rx_mode,
+	.ndo_set_mac_address = qede_set_mac_addr,
+	.ndo_validate_addr = eth_validate_addr,
+	.ndo_change_mtu = qede_change_mtu,
+	.ndo_vlan_rx_add_vid = qede_vlan_rx_add_vid,
+	.ndo_vlan_rx_kill_vid = qede_vlan_rx_kill_vid,
+	.ndo_set_features = qede_set_features,
+	.ndo_get_stats64 = qede_get_stats64,
+	.ndo_udp_tunnel_add = qede_udp_tunnel_add,
+	.ndo_udp_tunnel_del = qede_udp_tunnel_del,
+	.ndo_features_check = qede_features_check,
+};
+
 /* -------------------------------------------------------------------------
  * START OF PROBE / REMOVE
  * -------------------------------------------------------------------------
@@ -622,7 +639,10 @@ static void qede_init_ndev(struct qede_dev *edev)
 
 	ndev->watchdog_timeo = TX_TIMEOUT;
 
-	ndev->netdev_ops = &qede_netdev_ops;
+	if (IS_VF(edev))
+		ndev->netdev_ops = &qede_netdev_vf_ops;
+	else
+		ndev->netdev_ops = &qede_netdev_ops;
 
 	qede_set_ethtool_ops(ndev);
 
@@ -1313,6 +1333,9 @@ static void qede_free_mem_fp(struct qede_dev *edev, struct qede_fastpath *fp)
 	if (fp->type & QEDE_FASTPATH_RX)
 		qede_free_mem_rxq(edev, fp->rxq);
 
+	if (fp->type & QEDE_FASTPATH_XDP)
+		qede_free_mem_txq(edev, fp->xdp_tx);
+
 	if (fp->type & QEDE_FASTPATH_TX)
 		qede_free_mem_txq(edev, fp->txq);
 }